Search:

Type: Posts; User: RustlerBob

Page 1 of 5 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    11
    Views
    448

    Have u tried cleaning out your high speed needle...

    Have u tried cleaning out your high speed needle mine gets all gunked up after sitting a while?
  2. Replies
    3
    Views
    619

    I got the blue traxxas single chamber resonator...

    I got the blue traxxas single chamber resonator pipe and it does great it seemed to add a noticeable amount of power. It seemed to do alot better once i added the dual stage high flow air filter...
  3. Replies
    4
    Views
    310

    No ive tried every thing i put new fuel lines on...

    No ive tried every thing i put new fuel lines on new exhaust pipe and checked the tank. Once it warms up even with a full tank of fuel it will still act up. I sprayed wd40 all over the motor and fuel...
  4. Replies
    5
    Views
    142

    Did you have to do anything special when you...

    Did you have to do anything special when you added the 3.3 ?
  5. Replies
    5
    Views
    142

    Thanks for the info thats sumthin i havent tried...

    Thanks for the info thats sumthin i havent tried yet. What spur gear are you using with the 3.3? I have a 32p 72tooth on mine but i figured id go a little smaller when i get the 3.3
  6. Replies
    4
    Views
    310

    Any info helps

    Any info helps
  7. Replies
    4
    Views
    310

    traxxas 2.5 problems

    I have a nitro rustler with a stock 2.5 motor thats always been taken care of i always did the after run procedure. Its had almost 2gal of fuel ran through it and now it starts to run lean or just...
  8. Replies
    5
    Views
    142

    Thats an awesome video. How do you like your 3.3...

    Thats an awesome video. How do you like your 3.3 motor? Im thinking about upgrading to the 3.3 ive got the stock 2.5 still and have ran 2gal through it and its already having problems. It leans out...
  9. Replies
    29
    Views
    1,902

    Ya i guess ill get it warmed up and start sprayn...

    Ya i guess ill get it warmed up and start sprayn wd40 till i find where its suckn air. If its a main bearing i might as well get a new motor i guess. Thanks for the help
  10. Replies
    29
    Views
    1,902

    How was your old .15 motor running when u knew it...

    How was your old .15 motor running when u knew it was worn out? Was it doggy and cutting out when it got warmed up?
  11. Replies
    16
    Views
    561

    Ive went over just about everything as far as the...

    Ive went over just about everything as far as the tank fuel lines and filter ive set the carb settings 2 stock and adjusted them. It runs great untill it starts 2 get warmed up then it starts cutting...
  12. Replies
    16
    Views
    561

    runs lean when gets hot

    i have a nitro rustler that has a stock 2.5 motor and it has had almost 2 gallons of fuel run through it. It runs great until it hits about 200degrees then it starts to starve for fuel it seems...
  13. Replies
    22
    Views
    307

    Thats the same thing ive been doin I havent ran...

    Thats the same thing ive been doin I havent ran my rusty in a couple weeks cuz the heat, just been playn call of duty and halo reach.
  14. Replies
    7
    Views
    443

    As soon as i got my rustler i put front and rear...

    As soon as i got my rustler i put front and rear rpm a-arms and wide front bumper on. I also got a dual stage high flow air filter $15 bucks but well worth the money. I added the traxxas resonator...
  15. Replies
    30
    Views
    1,306

    Sounds like you have a dirty carb i have a nitro...

    Sounds like you have a dirty carb i have a nitro rustler had the same problems about a week ago. I thought it was time for a new motor and i was only halfway through my second gallon but i cleaned...
  16. thanks for the info im just gonna run the 2.5 as...

    thanks for the info im just gonna run the 2.5 as hard as i can till it blows and get a 3.3 . Does the 3.3 bolt right up or is there anything special ill have to do to install it?
  17. Replies
    7
    Views
    483

    i have a rustler with a stock 2.5 it has alot of...

    i have a rustler with a stock 2.5 it has alot of power but you always end up wanting more power. My 2.5 eats drive shafts already so if you go with the 3.3 i would stock up on tranny yokes and drive...
  18. Replies
    7
    Views
    483

    Ya i would go with the 3.3 for sure

    Ya i would go with the 3.3 for sure
  19. No never had 1 apart b4 but it doesnt look 2 bad....

    No never had 1 apart b4 but it doesnt look 2 bad. I just dont know how i got stuf in the carb im always real careful when im filling my tank so nothing falls in there. Is that just something that you...
  20. What would you recommend using to clean the carb...

    What would you recommend using to clean the carb with wd40? I would think regular carb and choke cleaner wouldnt be good for it especially if it has rubber o-rings on it.
  21. I just put new exhaust on the other day and...

    I just put new exhaust on the other day and shortened my pressure line to the tank. I checked everything over and everything seems fine fuel lines are good has a new glow plug also.
  22. New Engine??? Only gone through 1 1/2 gallons

    Ive ran about a gallon and a half of 10% fuel through my stock 2.5 traxxas motor now. About halfway through a tank or so it starts idleing higher and starts bogging out almost acts like its loosing...
  23. Replies
    2
    Views
    156

    My next nitro truck ?????

    I have a nitro rustler now but im looking for another nitro truck traxxas brand for sure. I was looking at the tmaxx 3.3 and the slayer pro 4x4. Anybody had any experience with either one? I was...
  24. Replies
    105
    Views
    2,326

    Also if you spray alot of wd40 in it after you...

    Also if you spray alot of wd40 in it after you run it, sum times i have to hold the throttle wide open for a little while when im crankn mine over to blow the wd40 out or after run oil.
  25. Replies
    105
    Views
    2,326

    Are you priming it up before you start? It could...

    Are you priming it up before you start? It could be a few things but if there is air in the fuel line it will do that. All you have to do is hold your finger over the exhaust for a few seconds while...
Results 1 to 25 of 111
Page 1 of 5 1 2 3 4