Search:

Differences between plastic & metal props. Is plastic bends once you put WOT so the speed is limited, metal props. is always straight, so you can get the best speed, as you mentioned about stability,...

Hog were enjoying the hot climate now here in Montreal, all week long Sunny or cloudy, no rain so far.

You didn't reach yet the LVD, it should slow down to 5o% the speed, be sure the esc light is Steady green not red.

There is called a Ghost hole on the hull, you can clearly see when you do it in a dark place.
1. Put a flashlight inside the hull were the other trim tab that your planning to put. So by that...

Well the important thing is you will receive it, rather than not.

This made by Jeffwholts, .187 is an upgrade, you need are those listed below.
1. .187 flex cable
2. Aeromarine coupler or Octura Coupler for .187
3. Stock copper tube without Teflon liner or...

Thanks for the Help now it's working. Got to get crawling.

I want to calibrate it, but I can't cause everytime I turn it on the rapid green light is blinking already. I unplugged the RX but it was the same thing green rapid light showing.

Any type of marine grease is fine.

Don't worry about the caps, if that happened your warranty last for a year from traxxas, be sure to keep your Receipt, flex cable should need to lubricated every 3runs, your spartan is supplied with...

Your Welcome Enjoy your New Toy soon!

It's the wire drive, typically called flexible wire in the Spartan, the .150 is for the stock wire drive while a .187 is an upgraded wire for 3S usage.

I have a new ESC with Low Voltage Detection, and replace my old EVX2, I plug in a 2s LIPO but then when I powered up the ESC it had a blinking green rapid light, there's a servo response but the...

Here is the additional Trim Tabs image
http://img.tapatalk.com/d/13/04/17/a7usumag.jpg

Here is the exact item #http://img.tapatalk.com/d/13/04/17/u9e4u3u9.jpg
You need the item # 5730 as well. ...

Longer run time and a bit increase in speed around 2+mph, NIMH are known for faster discharge, at first it will give you full performance but if your running for about 1-2mins. It will slows down and...

Props are Octura x442 or Prather 215 you can get it at OSE, the rubber motor jacket is the one which leaks water, try running with the aluminum jacket surely it will lessen the water. I'm not sure...

4S is not an issue running with the stock plastic prop. But if you go on reliability go with the metal props.

There is an option on the props if you want it sharpened and balanced. Around $25-30.

This is the water jacket, the white aluminum
http://img.tapatalk.com/d/13/04/14/5e9yge7u.jpg
Dual rudder conversion
http://img.tapatalk.com/d/13/04/14/aremubuj.jpg
Add up a silicon hose is for...

Firstly and most important is the water jacket, change it to Aluminum then the dual water pick-up just add up a little more on the silicon tubes.

Try recalibrating your transmitter to ESC.

20-30mph wind no problem, this is my favourite place, 1 more month then I will see the clear water.

Well if you play on the water like this far, you really need a rescue rig.
http://img.tapatalk.com/d/13/04/07/a7y4a7a2.jpg
It would be a tough time to use a Fishing pole.

You should upgrade to a bullet connector, heat problem cause by wires are the connectors, use higher amps. For a good flow of current through the wires.

Low Voltage indicator you need to charge your batts, I think your using the NIMH right?