Search:

hey man im a fire fighter in my city and i wouldnt recommend drilling holes in the ammo can for the reason that your allow oxygen to get into the can giving the fire its source of combustion if you...

Well i got to say that MIP sucks cause they made tons of people buy the original set then they told me that they wouldnt compensate for my old set so..I went with tekno and they rock man their cvds...

hey guys i want to buy a new motor i was thinking of getting the 550 ballistic motor but no clue on what esc to use.... i was wondering if anyone has had any problems with 550 ballistic and the havok...

guys today i put the new mip cvds to the test and they survived but i was sad to say that the drive hub the holds the small silver pin broke but the axle survived and the telescoping shaft did...

well i been using the new mip cvds there great well the rear ones the fronts i heard there are alot of problem from cracking to braking completly off but so far the rear ones get the job done i would...

true that cause i just had one of those ******* lipos go bad and i balanced on every charge i would watch them constantly cell one had 4.33 and cell two had 3.17 and i let it balanced out

hey guys just wondering what set up would you do for the front ,center, and rear diff if your track was indoor, clay hard packed, and lots of turns?:mellow:

heads up i realized that if you use the traxxas wheels they bend really bad and if you keep driving with them you start to wear down the plastic hexagon piece after the hub that also gives it a...

look any body is great and will last long time if you use fiberglass tape and shoe goo

hey did you guys see the flm axle upgrades you dont need to buy the cvds if you dont want them...

I been using the mip cvds and havent had a problem at all i actually enjoy them i had them on there for about 2 months....the only thing i did was shave down the cup and beveled the inside with my...

just to let those guys know that bought the proline shocks are going to be out of luck because if you mess up the internals you pretty much done unless you buy a new one... proline hasnt released any...

what's a merv

thanks for a great car design
i would like to see a buggy based off the erevo
i would like to also see that cvd kit you shown on the 4x4 intro page when it first came out

i would take off the screws and the plastic cover on the driveshaft ...dirt ,rocks and the screws will start to grind on the driveshaft and cause weak points

hey has anyone tried the rustler mip cvd kit? the only reason that ask this is because the rustler has alot in common with the slash 4x4...:mellow:

mean while people spend 100 to 140 or more ********* has them for 20 to 30 bucks ummm what would i get.....

Servo Tape Works Good For The Hole Areas

I Believe Alot Of Things Come In Conclusion...if You Look In The S1 Tires That Come With The Pe They Have The Cheapest Foam Inside Of Them And Wears Extremely Fast....the Wheel Itself Is Very...

the axles are not bending because of bearings or the hole .....the bending of the axles has to do with alot of things but not those two. upwheel travel, oil wt, and the driver skill are some of the...

well if you have the slipper it will be the same one as the jato
and if its from the center diff you are out of luck till they release it

Edited for Language
-ksb51rl

why dont try this one i used it and it works great very cheap. intergy rc 540 motor heatsink and cooling fan
http://www.integy.com/st_prod.html?p_prodid=6232&p_catid=109

64 + 1 = 65

no one right just traxxas but you can us 2753x and they will work

I Got Parts Yesterday For It Go To Ultimate Hobbies .com They Get Direct From Traxxas