Search:

Type: Posts; User: Rourke

Page 1 of 4 1 2 3 4

Search: Search took 0.17 seconds.

  1. Thread: Rough Day

    by Rourke
    Replies
    10
    Views
    236

    Rough Day

    Yesterday when I was bashing my stampede, my proline trenchers tore. Has this happened to anyone else? Im angry because the tires are less than a month old, and I dont think ill be able to get the...
  2. It will fit but I dont recomend using the rpm...

    It will fit but I dont recomend using the rpm gear box.
  3. Replies
    28
    Views
    610

    http://img.tapatalk.com/d/14/05/08/y5ederyz.jpg

    http://img.tapatalk.com/d/14/05/08/y5ederyz.jpg
  4. Replies
    10
    Views
    306

    I am running the castle sct combo on 3s. I have...

    I am running the castle sct combo on 3s. I have gearing 54/14 and usually temps are warm to hot after a full run. You just have to be cautious and check temps a few times a run.
  5. Replies
    23
    Views
    407

    I don't run a body. Just some body mount that are...

    I don't run a body. Just some body mount that are high, and I let them wear down.
  6. Thread: I need help

    by Rourke
    Replies
    3
    Views
    104

    If you could post a picture, we could help you a...

    If you could post a picture, we could help you a lot easier.
  7. Replies
    10
    Views
    240

    Staying on The Ground After a Jump

    Well when I only use the stock shocks when the truck was brushed . Once I went brushless, my friend gave me the shocks for free.
  8. Replies
    10
    Views
    240

    The shock oil is what ever is stock. I'm not...

    The shock oil is what ever is stock. I'm not positive but I'm pretty sure it's 30. The reason why I put so much preload is because these shocks are longer than stock.
    Thanks
  9. Replies
    10
    Views
    240

    In this video you can see how it doesn't want to...

    In this video you can see how it doesn't want to land.

    http://youtu.be/VOdySqypuF0
  10. Replies
    10
    Views
    240

    Staying on The Ground After a Jump

    These are some picks of my setup.

    http://img.tapatalk.com/d/14/04/13/eqatavaq.jpghttp://img.tapatalk.com/d/14/04/13/5yryte9a.jpg
  11. Replies
    10
    Views
    240

    Staying on The Ground After a Jump

    Hey guys.
    I have been doing some heavy bashing on my truck lately but when ever I go off a jump onto grass it almost alway flips over or rolls over, no matter how perfect the landing is. Right now I...
  12. Sticky: https://www.youtube.com/watch?v=VOdySqypuF0 ...

    https://www.youtube.com/watch?v=VOdySqypuF0

    Same as the one above
  13. Sticky: https://www.youtube.com/watch?v=VOdySqypuF0 ...

    https://www.youtube.com/watch?v=VOdySqypuF0

    CHECK IT OUT.
  14. Replies
    8
    Views
    299

    Slash 4x4 gearing with stampede tires

    I would recommend taking off the motor fan to see. If the temps are bellow 150 after running one pack. Then you should move up to either a 13 or 14 tooth pinion gear depending on how close to 150 the...
  15. Replies
    18
    Views
    256

    Right now am using axle pins. It is definite...

    Right now am using axle pins. It is definite jammed in. The problem is that the pin is very large so it make the gear that sits lower on the shaft. That means when I have the tranny all assembled the...
  16. Replies
    18
    Views
    256

    It may have fallen out I'm not sure. How do you...

    It may have fallen out I'm not sure. How do you keep it from falling out? Thanks
  17. Replies
    18
    Views
    256

    I truer the hex method and it broke right away....

    I truer the hex method and it broke right away. Any other suggestions
  18. Replies
    18
    Views
    256

    Thanks so much I'll try to get it done tomorrow

    Thanks so much I'll try to get it done tomorrow
  19. Replies
    18
    Views
    256

    So if I ream it out and shove the hex in, that...

    So if I ream it out and shove the hex in, that will do the trick?
  20. Replies
    18
    Views
    256

    Transmission Problems. HELP

    So I went to go drive my stampede today and in the middle of driving I suddenly had no throttle response. I took a look at my truck and I noticed that the shaft that goes from the spur gear and...
  21. Replies
    18
    Views
    390

    Thanks for all the input guys. It was the ears of...

    Thanks for all the input guys. It was the ears of the stub axle that kept breaking. My order should be in on Friday and then I look forward to putting them thorough their paces.

    And quick...
  22. Replies
    18
    Views
    390

    Best drive shaft upgrade?

    I'm sorry but what are the HD shafts?

    Edit: looked it up and I'm gonna order 6852x
  23. Replies
    18
    Views
    390

    Best drive shaft upgrade?

    Hey guys,
    After receiving my castle creations short course combo, I have already broken 2 stub axles. I believe I heard that the stampede/slash 4x4 drive shafts hold up a lot better. Do you guys run...
  24. Replies
    14
    Views
    364

    Thanks for the link. How does the roll cage hold...

    Thanks for the link. How does the roll cage hold up for heavy bashing? I know integy has a bad reputation.
  25. Replies
    14
    Views
    364

    It's fine I'll just stick with the chassis the...

    It's fine I'll just stick with the chassis the way it is. I think I just want it to look better with the body on. I think I'm just going to get a roll cage.

    Thanks everyone who pitched in.
Results 1 to 25 of 100
Page 1 of 4 1 2 3 4