Type: Posts; User: kgombe1
cheapest wings, if you can still find them, is the racers edge wing, I may have bought them all back in the day when i saw them for 3.99, found 4 in my pile of wasted hobby cash just last week... LOL
your clutch spring or clutch shoe is broken..
this is the clutch on your engine
How to diagnose this problem?
1) is the spur gear moving,
if yes, look at shaft of opposite side of spur on the trans.. thats the primary shaft, if that is moving proceed to step 2.
its awesome... you will feel the difference in performance... yes i had them installed on my engine, also keep in mind that plugs are more expensive
I maybe lost of memory, but the Tekno tank conversion moves the tank higher or higher and forward never in the same location..... But I'm getting old. Who knows i may be wrong.
depends ... could be tank location as well :-)
well more power to you on that.... the real test is run the truck consistently in a left handed circle and see if it comes back..
I'm happy its working for you!!!
yup thats the same issue with the RB engines... trust me when i say it's not the tank.. they have been many theories behind this, some had fixes.. that they said worked but i call *@ on that..
Did you have turn left at any point in the section of the track?
Correct.. just didn't want to use the manufacturers name and changing fuel tanks did nothing..
What he said ^^^^ except that for some engines, not the 3.3, you had a left turn lean bog issue... But that's not a concern as the 3.3 was fine
Cogging is cause by it being a non sensored system, but if there is not enough voltage to get the motor spinning or truck moving you will have a similar effect as Cogging, bad it will be worst. 2s is...
Oops .. Wrong thread
Great news on the truck... Have fun
Only the second gear is changed in the 3.3 from standard to wide... Wide ratio only good for high speed runs.
Revo will be a good beginner truck.. Listen to opinions of those that own it and those making comparisons have to own both... The truck is easier to work on...
when i ran MT back in the day i ran better with 1/2 offset, but my fellow racer ran well with zero offset.. i drove hard into the corners and rolled into it, he would break into the corner and exit...
it doesn't matter where the tank is mounted... the chassis breaks between the tabs.. we all mluonted our tanks like that more than 6 + years ago because to get 150cc.. so trust me when i say... brace...
Make sure you bridge those 2 tabs together with a pce of aluminum or carbon fiber or that chassis will start to crack right there and eventually break right across to the engine
Yup pitch is wrong... I never used those CB before... And usually use the HPI bell as stated...
Looks great cyborg
You should be fine.. Revo uses mod 1 which is 1/8 scale
Nooo .. That doesn't really play a big part... But it sounds like you have a mod 1 and mod .8 mesh.. I can't rem which is which right now
Where did you buy it and what vehicle is it made for