Search:

Type: Posts; User: cjhike

Page 1 of 2 1 2

Search: Search took 0.06 seconds.

  1. Replies
    18
    Views
    599

    When you charge with the Traxxas you need to use...

    When you charge with the Traxxas you need to use the optional board to split out the leads to charge. In doing so your voltage will remain the same, however your current will cut in half to 3 amps...
  2. Replies
    18
    Views
    599

    You may want to look at the Duratrax Oynx 245...

    You may want to look at the Duratrax Oynx 245 charger for your batteries - It is a little more money at $130, however it will charge two batteries at the sames time without having to split the...
  3. You want your truck to bottom out on larger jumps...

    You want your truck to bottom out on larger jumps - it takes stress off of some of the suspension components. They were designed to do it.

    For sure try the stiffer springs and thicker oil,...
  4. Cut or melt two small holes on each side of the...

    Cut or melt two small holes on each side of the tire in the middle of the tread, really small holes (1/8 inch). Then hold the truck, put in high gear and give it full throttle. This should spin the...
  5. Replies
    3
    Views
    159

    There is a photo in the Picture thread with...

    There is a photo in the Picture thread with bigger tires.

    http://traxxas.com/forums/showthread.php?537091-The-Official-Traxxas-Stampede-4x4-Photo-Gallery-Post-your-pictures-here!

    It is about...
  6. Replies
    37
    Views
    644

    25c would be all you need for a stock truck - a...

    25c would be all you need for a stock truck - a higher C rated battery would not increase performance.
  7. Thread: motor question

    by cjhike
    Replies
    7
    Views
    105

    WOW - The google link - That was nice and rude! ...

    WOW - The google link - That was nice and rude! :thumbup:

    Onebadtmaxx - you can go with the above mentioned Castle motor in a combo with the ESC and fan for about $120. Will give you more...
  8. Thread: motor question

    by cjhike
    Replies
    7
    Views
    105

    You could use the Castle 3800kv SCT (1410) -...

    You could use the Castle 3800kv SCT (1410) - should bolt right in and will give you quite a bit more torque as it is a 4 pole motor.
  9. Replies
    14
    Views
    242

    I have the Duratrax Oynx 235 - happy with it. ...

    I have the Duratrax Oynx 235 - happy with it. However I wish I would have bought the Duratrax Oynx 245 for only $20 bucks more. The 245 will charge two batteries at once.
  10. Thread: How many ?

    by cjhike
    Replies
    6
    Views
    153

    I have, - 3 - Duratrax 25C 5000mah 2S - 2 - SPC...

    I have,
    - 3 - Duratrax 25C 5000mah 2S
    - 2 - SPC Racing 50C 8200mah 2S

    However only a single charger.... so it would take me 7.5 hours to charge all, going to have to upgrade that!
  11. Replies
    8
    Views
    253

    Run mine in the snow all the time with no...

    Run mine in the snow all the time with no rusting. When I come in I give it a rinse, then shake off, then towel dry, then sit in front of an electric heater for about 30 minutes.
  12. Replies
    10
    Views
    273

    Hey - would suggest that it is the temp, around...

    Hey - would suggest that it is the temp, around freezing or below I notice my run times drop fairly quickly. Especially if running in snow, with the extra resistance as well as it packing around the...
  13. Replies
    24
    Views
    743

    WOW!!!! Awesome job!!!

    WOW!!!! Awesome job!!!
  14. Replies
    26
    Views
    648

    Just put mine on... Front went on with no...

    Just put mine on... Front went on with no problems, took about 5 minutes. The rear, well they took a bit longer (10 minutes) - ended up flipping over the backer plate and the screw caught. It did...
  15. Summit!!!!!!

    Summit!!!!!!
  16. Thread: Lipos in Summit

    by cjhike
    Replies
    15
    Views
    521

    You do not have to, however if you remove some of...

    You do not have to, however if you remove some of the fins on the rear battery vents you can run the wires through them. Easier to connect and install that routing out the sides...
  17. Replies
    30
    Views
    565

    Can not see the turbo fan being better that a...

    Can not see the turbo fan being better that a standard heat sink and fan combo. As the turbo fan would be running off of the motor itself - they faster you go the more drag on your motor, which in...
  18. Looks good! The shocks are not supposed to come...

    Looks good! The shocks are not supposed to come all of the way back up after being compressed. The truck after being compressed should come up so the front arms sit just above level. It looks like...
  19. Replies
    47
    Views
    1,522

    Looks Good! Can you list all of the parts you...

    Looks Good! Can you list all of the parts you had to use to do the transformation?
  20. Replies
    23
    Views
    582

    Yes, however the SPC batteries mentioned above...

    Yes, however the SPC batteries mentioned above are what a lot of people run - they are really the best choice in my opinion... And a lot less $$
  21. Replies
    24
    Views
    511

    I have the JConcepts Ford Raptor body and would...

    I have the JConcepts Ford Raptor body and would not buy again. It is wider than the Proline one and the front tires rub with almost any shock compression. Also have not found it to be very...
  22. Replies
    4
    Views
    137

    I have the one with telemetry on order right now...

    I have the one with telemetry on order right now - I called them when ordered and they said that they are replacing the one without telemetry with the new one with telemetry. Just selling the one...
  23. Replies
    4
    Views
    137

    Depends on whether you plan to purchase the...

    Depends on whether you plan to purchase the telemetry connections down the road... But they are the same price so why not get the one with the mounts?
  24. Replies
    19
    Views
    791

    The Velineon motor can get pretty hot when...

    The Velineon motor can get pretty hot when running Lipos - on 2S mine runs around 135 - 140 degrees. Meaning you can touch the motor for 4 - 5 seconds before it starts to really hurt. The motor is...
  25. Replies
    24
    Views
    659

    Charged mine from the cut off point and put...

    Charged mine from the cut off point and put 5200mah into them. If I used a separate LVA and ran them down to 3.4 volts should increase the run times. Although the snow I am running through is 5-6...
Results 1 to 25 of 35
Page 1 of 2 1 2