Type: Posts; User: q8-maxx
i fixed the tranny after broke the pin that goes into revo shaft in gorilla single speed. sure that after bashing my emax with 5s.
(I will upload the video soon).
and here is my bashing with 4s...
I understand you you means use new e-maxx 3905 slipper in the old e-maxx 3906
you can use the revo input shaft but you have to modfiy it to the tranny box.
i have done tips for this upgrade with...
e-maxx 5s last week jumps
you can buy FLM shocktower instead of truggy shocks. then you can lower your emaxx as you like
I dont think so. but to be sure wait the reply from someone has them :)
if you means FLM
FLM chassis come with drive shaft (dogbone)
3906 and 14c hv4.5
FLM chassis - E-maxx 4s bashing (medusa...
E-maxx 4s bashing (medusa 70-2300)
E-maxx 6s bashing (1515/y smooth can)
scotthw I just check the speed from Speed Calculator
your speed with 20/68 was 38mph (mashers 40)
your speed with 24/68 will be 40mph (mashers 3.2)
24/58 and 24/62 was my best gearing for 4s with masher 3.2
or use Speed Calculator
masher 40 = 6.6
masher 3.2 = 5.8
so you have to gear it up about 2 tooth or 4
if you want run time, max speed, average speed, distance traveled. garmin forerunner 101 is for you I have one :)
i hold my ***** lipo like that
and here with my hard case lipo
you just need a balancer connecter
* you must know what is the balancer tab...
my mip's run for 2 years no issues yet i'm talking about 2.5 version for old e-maxx and sure its run with brushless power 45-50 mph
but I have the traxxax cvd and I prefer it
That for sure 2s+3s will balance your e-max more than 2x3s or 2x2s.
put the 2s in motor side and the 3s in the other.
you have to use same brand, mah, and c battery. here is the example for what...
if you talking about the Traxxas Driveshafts Center E-Maxx it has 2 side one of them has a bone that connect to the cup.
so the side that has a bone will connect to the Hot Bodies Output Joint...
you have to use 8mm joint. I use this Hot Bodies Output Joint Lightning Series
you need 2 not one :)
the HB diff use output drive cup and its to short so you need to open the HB diff and replace the drive cup.
here is my way to avoid this problem:
I used Traxxas CVD with FLM and Hot...
I just update firmeware for ezrun 150a by lcd program card. and now the ESC not response if i go forward or back so i have to restart the ESC or wait more than 15 sec's to can move again . any1 face...
I love my duartrax skid with rpm wear. sure they are bent but you can fix them. they last 2 years :wub:
02hawk :wacko: :wacko: ;) keep your sister away from your computer :p :p
slash 4x4 yeeeeeeeees
i said its rustler but came as slash