Search:

Hi Sorry bout your truck. If you will search this site you will find the answers you need. Usually a signal interrupt causes your problem, could be an outside source (interference) or could be...

Hi There is a correct way to put a clutch spring on, or a better way. If you search for the link on this site I am sure you will find an answer to your question.

Hi Nitro Newbie Welcome to fuel. The answer to your glow igniter question is no, you do not need one with an ez starter. The starter wand replaces it. Plenty of help out there just ask.

Hi again. Forgot to tell you go on e bay and get an owners manual for it That is your bible for right now, tells you everything you need to know including break-in and maintenance and parts...

Hi Welcome to the world of rc. Sounds like the ez wand needs to be charged. Until then see if u can spin the motor over by hand. On the exhaust side of the motor looking at the car from the side...

Thanks for the info, appreciate it.

Hi I have a t maxx with a metal carburetor and a brass adapter sleeve. What expoxy or glue would I use to glue the sleeve to the carb? Thanks

Hi Try this, Get a small length of fuel line, disconnect your fuel line from the carburetor, attach the new fuel line to the inlet on the carburetor. Then get a spray bottle of soapy water and...

Hi Read your problem. Did you put the ring that goes between the glow plug and the engine on right? The ring needs to go flat side down to get a good seal, or you could have the problems you are...

Hi Read youl link Stupid question Have you put the ring that goes between the glow plug and the engine on the right way? It needs to gol flat side down. Also try turning the engine over with the...

Hi Need to make a correction! For the better tranny mount screws, use traxxas #2584 3x12 cooling head capscrews. Tried them and they work great.

Hi The Losi is a palstic carb, try going under o.s. 18/21 trz

Hi Wildman Thanks for the info, used header cap screws with chassis braces and works great.

Hi. Don't know what your runnning, but a 2.5 and 3.3 carb is the same. Have a 3.3 with a metal carb and love it. Ther are a few carb replacements, but not cheap, around $80 and up. If you...

Hi On the transmission mounts, used traxxas header screws. The screws are cap screws which worked fine. I think I had to drill out one hole just slightly so the screw would fit deeper. Still...

Hi I think wildman is right, upgrading a 4910 right now. Start with a better sending system and upgrades already there!

Hi Looks like you are holding the front of the brake rod at the horn when you manually push on the brakes causing the rod to be forced back into the tranny, check it out

I took my ez start off, took it apart(ez to do) and drilled a hole in the middle of the case where the OWB fits, the hole needs to be the size of the red tube on a can of wd-40, put it back together....

Hi Need info. Do I have to reset an ofna failsafe every time I change the batteries 1-on the car 2-in the controller or do I have to reset it at all? The trucks are traxxas t maxx. Thanks

Hi Be sure to put the bearing back in with the lettering on the OWB facing the engine, hope it gets going for you!

Be sure to put the OWB with the printing on the bearing facing the motor or the motor will not turn over the bearing will just spin

Put the owb on with the lettering that is on the owb facing the engine

Hi Other than tune, check slipper clutch and tighten it Still having problems check clutchbell lower number of teeth to 18 or 19

Great flow chart! Copied it immediately. Thanks for the info!

Newer version