Search:

Type: Posts; User: 68rocks

Page 1 of 16 1 2 3 4

Search: Search took 0.12 seconds.

  1. Replies
    7
    Views
    179

    Some tires don't require foam inserts. My Proline...

    Some tires don't require foam inserts. My Proline Dirt Paws do not require them. (says on the package)
  2. Replies
    14
    Views
    310

    Here:...

    Here: http://www.rpmrcproducts.com/products/traxxas/SandR1.htm
  3. That's what the forums are for! Now go drive it...

    That's what the forums are for! Now go drive it like you stole it!
  4. What is the worst thing that can happen? Think...

    What is the worst thing that can happen? Think about it...motor...ESC...that can happen any day of the year, no matter how many times you drive it. One freak thing and BAMM! Don't worry and drive it...
  5. Replies
    9
    Views
    170

    7cell and 2s are about the same power, difference...

    7cell and 2s are about the same power, difference is that the NiMH "slows" with every run...2s Lipo doesn't. Make sure if you go lipo that you don't let the little guy charge it, do it yourself. Too...
  6. Replies
    10
    Views
    146

    I did away with the expansion kit risers and used...

    I did away with the expansion kit risers and used some spare ball ends under the ESC plate. It only raises the ESC about half of the included risers, which was enough for my 3s battery & ESC Fan to...
  7. Replies
    39
    Views
    714

    I don't think those wheels have hexes to mount to...

    I don't think those wheels have hexes to mount to the eRustler, you need the the hexes on the inside of the wheels & maybe look into 2.8 wheels.
  8. Replies
    39
    Views
    714

    Do tell! I have been having this problem for over...

    Do tell! I have been having this problem for over a year & can't figure anything out. Sometimes it wont move, just gives a quick little beep...sometimes a little push gets it going again...only after...
  9. Replies
    3
    Views
    110

    I would think if they were 2.2 with 12mm hexes...

    I would think if they were 2.2 with 12mm hexes they would work. Considering you bought the traxxas 12mm hexes & axles for the rustler. I think the stub axles for the bandit are too short to hold the...
  10. Thread: Chargers

    by 68rocks
    Replies
    7
    Views
    183

    Or if you are crafty, here is a vid of converting...

    Or if you are crafty, here is a vid of converting a Computer power supply into a 12v DC power supply...http://www.youtube.com/watch?v=o8GoFUwDM4M
  11. Replies
    2
    Views
    144

    I've had some pretty serious wrecks and I have...

    I've had some pretty serious wrecks and I have the TRX Aluminum camber links all around, never had an issue with them bending (they are pretty thick and stout). Maybe I was just lucky.
  12. Thread: newbe here

    by 68rocks
    Replies
    6
    Views
    137

    Check out spcracing.com for very reasonable lipo...

    Check out spcracing.com for very reasonable lipo batteries ($30-$40 for a 5000mah 2s)...good quality too
  13. Replies
    6
    Views
    218

    The cap can't twist when on the truck, it's the...

    The cap can't twist when on the truck, it's the shock body that is spinning. Do your springs rub on the shock body forcing the body to spin down? Shock shafts bent?
  14. Thread: Shocks

    by 68rocks
    Replies
    18
    Views
    283

    Look Here: (I know they are Integy, but they are...

    Look Here: (I know they are Integy, but they are only springs)

    http://www.rcplanet.com/Integy_Tuned_Spring_Set_p/INTT7984.htm?gclid=CJ_G1cHbjbwCFSUOOgodiT4AcA
  15. Replies
    5
    Views
    104

    You could always splice a piece of wire onto the...

    You could always splice a piece of wire onto the remaining wire and cut off the other plug and install another type of male and female connector (remember to solder and heat shrink the joints)
  16. IMO I would get an aluminum tranny case and scrap...

    IMO I would get an aluminum tranny case and scrap the heat sink idea. I got the FLM case and it dropped my temps by about 35
  17. I use what many on the boards here use. Traxxas...

    I use what many on the boards here use. Traxxas Aluminum Castors, Traxxas Aluminum Bearing Carriers (or RPM), and RPM Arms. Worked well for me. Other mfg's have great aluminum parts too...
  18. Replies
    36
    Views
    2,224

    1410 series...look here:...

    1410 series...look here: http://www.castlecreations.com/products/nc1410.html
  19. Thread: lipo question

    by 68rocks
    Replies
    13
    Views
    365

    No doubt...SPC! I have Hard Paks and soft...

    No doubt...SPC! I have Hard Paks and soft paks...great value!
  20. Replies
    4
    Views
    116

    My post display changed recently to display "Last...

    My post display changed recently to display "Last day" of threads also...you need to scroll down and change it to "Last week" or to your liking.
  21. Replies
    12
    Views
    304

    19T will be a little slower, but the trade-off is...

    19T will be a little slower, but the trade-off is more torque. I run 19T for on and off road and for me it is a good medium.
  22. Replies
    10
    Views
    233

    Proline Gladiators

    Proline Gladiators
  23. Replies
    8
    Views
    200

    for a bandit you will need to replace the arms...

    for a bandit you will need to replace the arms too or the tires will rub
  24. Replies
    8
    Views
    200

    You'll need a set of hexes (#1654 rear & #3654...

    You'll need a set of hexes (#1654 rear & #3654 front) and a set of hex hub wheels(12mm hubs for rusty)

    (I'm not sure, but you may need the rustler axles too.....don't think so though)
  25. Replies
    5
    Views
    183

    SPCracincg.com for great lipos...and don't forget...

    SPCracincg.com for great lipos...and don't forget the RPM front bumper!
Results 1 to 25 of 378
Page 1 of 16 1 2 3 4