Search:

Type: Posts; User: u189961

Search: Search took 0.37 seconds.

  1. is there an alternate engine mount for picco .26?

    hi!

    I seem to be having issues with the OFNA motor mount. the threading always seem to fail and i end up having 3 bolts secure the motor. I did look into the Traxxas BB mount but not 100% sure if...
  2. Replies
    3
    Views
    314

    Odd temp readings with new head.

    hi. I have a Picco .26 in the Revo and recently swapped out the heads due to the picco head bending some heat sinks. I installed a head that is non anodized alluminum. I use the Duratrax temp gun.
    ...
  3. thanks for the info and flames. i was under the...

    thanks for the info and flames. i was under the impression that the overall size of the spur was the same regardless of teeth. it makes sense now. ill adjust the motor mount so that they mesh...
  4. 36T Spur does not match up with clutch bell..

    hi there. At the moment, I am running a 17/38 combo w/ the picco .26 max. I ordered a 36T spur, but for some reason, it doesnt match up with the clutch bell as they dont make contact. it almost seems...
  5. Replies
    24
    Views
    1,211

    thanks for the info guys! keep em coming!

    thanks for the info guys! keep em coming!
  6. Replies
    24
    Views
    1,211

    Finally got my OFNA Picco .26!!

    hello all! i jsut received my ofna .26 and motor mount for my revo!!! My 3.3 went out over this past weekend, con rod decided to go out :mad: ! Im good at tuning and had it running perfectly not...
  7. my apologies, i should have mentioned that... its...

    my apologies, i should have mentioned that... its a 3.3 w/ roughly about 2 gallons through the engine. i have always been careful not to exceed 250 F. thanks
  8. Engine dies shortly after high speed/a bit fo bashing

    hello all,

    im fairly good at tuning my revo. i recently swapped out the spur gear and CB gear and wasnt running right. I then proceeded to reset all the needles back to stock, HSN 4 turns out and...
  9. I appreciate the input thanks! you brought up a...

    I appreciate the input thanks! you brought up a good point when you mentioned the alignment. I don't think my chassis is bent, but i will check it out. thanks again.
  10. trouble shooting stripped spur gear/blown bearings

    hello all! 1st time poster, long time reader and revo owner!

    I have recently gone through 2 spur gears in a matter of 1 week and just yesterday, i blew the bearings in the clutch bell. the...
Results 1 to 10 of 10