Search:

Type: Posts; User: luckybobb

Page 1 of 9 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    9
    Views
    188

    It you lift the rear end up off the ground do the...

    It you lift the rear end up off the ground do the wheels spin?
    If they do does the clicking sound still occur?
  2. Replies
    12
    Views
    291

    I see a few different tires on the workbench, is...

    I see a few different tires on the workbench, is it possible in doing all of the work that a front and rear wheel got mixed up? They have different offsets that might explain the difference in...
  3. Replies
    7
    Views
    240

    Some of the differences i am aware of (unless...

    Some of the differences i am aware of (unless things have changed recently),

    Vxl has bearings instead of bushings
    Vxl has hex screws where the xl5 has phillips
    Vxl has a different esc mounting...
  4. Replies
    4
    Views
    144

    Did you calibrate the new radio to the esc?

    Did you calibrate the new radio to the esc?
  5. Replies
    5
    Views
    483

    Is there any special reason you want a lipo to...

    Is there any special reason you want a lipo to power an EZstart as far as i know there is no reason for a lipo for that application you could buy an inexpensive nimh for that and it would be...
  6. Replies
    9
    Views
    166

    I beleive the xl-2,5 is for a 1/16th scale...

    I beleive the xl-2,5 is for a 1/16th scale vehicle. If i had to guess putting that in something the size of a stampede was more than it could handle, and that is why it smoked.
  7. Replies
    13
    Views
    250

    As far as i know adjusting the torque limit is...

    As far as i know adjusting the torque limit is not available on the vxl, only on the castle esc.
  8. Replies
    17
    Views
    202

    I had them falling out while running then i...

    I had them falling out while running then i realized the front and back tires have different offsets and if the rear rims are put on the front you will not be able th tighten the nut down all of the...
  9. Replies
    11
    Views
    118

    I don't know how hard it would be to repair the...

    I don't know how hard it would be to repair the receiver, at the time i had an extra one so just swapped it out.
  10. Replies
    11
    Views
    118

    Could be the antenna was damaged inside the...

    Could be the antenna was damaged inside the receiver (i had that happen with an old am).
    Can you try the other remote with the old receiver? If you can that would atleast tell you wich one needs to...
  11. Replies
    40
    Views
    806

    You both will figure out soon enough that part of...

    You both will figure out soon enough that part of the fun of this hobby is tearing it aoart and fixing the carwhen it breaks. One of the things i love about the Rustler is how easy it is to work on.
  12. Replies
    1
    Views
    54

    motor kv question

    I had a 3800kv motor in my rustler and through vertain circumstance (non waterproof esc) i jad to stop using it.

    I have been told that the 3800 has alot of torque and is "an amp hog" when kt...
  13. Replies
    7
    Views
    4,914

    Lowlow sorry that was meant for the original...

    Lowlow sorry that was meant for the original poster. If you are using LiPO, DO NOT thrn off the LVD you can run the bttery down too far and damage it. I admittedly don't know too about lipo but i...
  14. Replies
    7
    Views
    4,914

    I am not sure if it makes a differenc but 9volts...

    I am not sure if it makes a differenc but 9volts is not fully charged for a 7cell NIMH. What was the voltage after using the traxxas charger? Are you positive that LVD was turned off (solid red...
  15. Replies
    7
    Views
    387

    I would check all of the gears and make sure they...

    I would check all of the gears and make sure they aren't stripped and the mesh is set correctly
  16. Replies
    4
    Views
    149

    Have you checked that the slipper clutch is tight...

    Have you checked that the slipper clutch is tight enough and that the pads aren't worn down?
  17. Replies
    3
    Views
    151

    Laid it horizontally between the receiver and the...

    Laid it horizontally between the receiver and the battery tray (not sure if there is room on yours but mine had just enough room to wedge it in there and it was held in pretty snug).
  18. Replies
    3
    Views
    151

    I used to run fm and what i found to do about the...

    I used to run fm and what i found to do about the antenna length is to take a piece of a soda straw, put a small in each end, pull antenna through one hole and wrap as much as need to around the...
  19. I had to use the remote to change that setting...

    I had to use the remote to change that setting (the directions are in the manual) and the problem is you have to go through all of the settings to save the change.
    It it much easier to do with te...
  20. Thread: Old 'pede

    by luckybobb
    Replies
    17
    Views
    354

    I would say check all of the connections between...

    I would say check all of the connections between the esc and receiver, and between the esc and the motor. You may have bad motors.
  21. With the regards with the motor fan the only way...

    With the regards with the motor fan the only way i was able to mount it properly was to cut part of the tranny case.
  22. I had the sct 3800 in my rustler running on nimh...

    I had the sct 3800 in my rustler running on nimh and had no problems you just to watch the gearing as the motkr will draw alot and make the pack heat up. From what i hear it would be much better on...
  23. Replies
    20
    Views
    467

    i had an old AM system in mine and it did some...

    i had an old AM system in mine and it did some weird things (suddenly turn when i got to a certain spot and occasionally some motor jittering) changed to a 2.4 ghz system that got for 35 bucks and...
  24. Replies
    39
    Views
    1,002

    If you go to the wabpage for the truck cl i ck...

    If you go to the wabpage for the truck cl i ck downloads and the on parts list and there will be a traxxas power cell guide that will tell you what batteries (lipo and nimh) will fit.
  25. As an electrician I deal with "waterproof" things...

    As an electrician I deal with "waterproof" things all of the time, and from my experience for the most part no matter what if you throw enough water at hard and fasy enough some will get in. I...
Results 1 to 25 of 222
Page 1 of 9 1 2 3 4