Search:

Type: Posts; User: b5125125

Search: Search took 0.00 seconds.

  1. Replies
    9
    Views
    486

    it would only stall when the engine was warmed...

    it would only stall when the engine was warmed up,also would only start with the wheels off the ground once warmed up...thanks
  2. Replies
    6
    Views
    614

    the one that comes closes to the fly wheel where...

    the one that comes closes to the fly wheel where the magnates are, that's what the sensor picks up
    hope it helps
  3. Replies
    9
    Views
    486

    finally :thumbup:, it was the bell clutch that...

    finally :thumbup:, it was the bell clutch that had a broken spring and was always engaged witch made the truck creep forward and kept the engine rpm high even when I would let off the gas as was...
  4. Replies
    9
    Views
    486

    yeah I'm going to adjust LSN again and my HSN is...

    yeah I'm going to adjust LSN again and my HSN is fine

    I started to seal my back plate and carb and while the engine was out I decided to check the bell clutch and found a broken spring:O.o: I...
  5. Replies
    9
    Views
    486

    I set the LSN to 1.75 turns and it was bogging...

    I set the LSN to 1.75 turns and it was bogging from take off so turned it to down to about 1.25 and it stopped doing that but the pinch test was about 2 sec. and my temps were ok..
    then I started...
  6. Replies
    9
    Views
    486

    ok I'll give it a shot tomorrow thanks

    ok I'll give it a shot tomorrow thanks
  7. Replies
    9
    Views
    486

    can't get it to idle

    I have a 3.3 that was just broken in.
    I'm have trouble getting it to idle, when I took off the air filter to check the gap for idling I noticed that it would spit nitro back out when I would rev...
  8. the link doesn't work

    the link doesn't work
Results 1 to 8 of 8