Search:

Type: Posts; User: zach23

Page 1 of 7 1 2 3 4

Search: Search took 0.27 seconds.

  1. Thread: LiPo questions

    by zach23
    Replies
    16
    Views
    612

    I also think that 2x 2S in parallel delivers more...

    I also think that 2x 2S in parallel delivers more power to the system, since both batteries are drained and ESC has more amps to feed the motor.
  2. Have you tried both servo channels? Possibly only...

    Have you tried both servo channels? Possibly only broken, badly bend wire???
    Can you double check servo on a different/operating system? How old is your BB?
  3. Thread: LiPo Problems

    by zach23
    Replies
    12
    Views
    184

    What batteries? What charger? Lipos were balanced...

    What batteries? What charger? Lipos were balanced properly and undamaged? There is a lot of questions to investigate what has happened. I hope your electronics is OK!
  4. Replies
    2
    Views
    112

    OK - it is hex 1,3mm

    OK - it is hex 1,3mm
  5. Replies
    2
    Views
    112

    I've found it is 0,50". Should be 1,2mm hex. Will...

    I've found it is 0,50". Should be 1,2mm hex. Will confirm when I check which bit fits.
  6. And my guess would be worn gears inside the servo...

    And my guess would be worn gears inside the servo itself. The final gear that you attach servo horn on the "inside" is connected to the potentiometer that tells the servo position of the horn. To me...
  7. http://img683.imageshack.us/img683/4686/43641234.j...

    http://img683.imageshack.us/img683/4686/43641234.jpg
  8. Thread: Mudding!!!!

    by zach23
    Replies
    35
    Views
    625

    If in doubt keep exploaded prints at hand and...

    If in doubt keep exploaded prints at hand and most of maintance jobs you can easly find on Youtube for guidance.
  9. Chassis braces from thetoyz add a lot to overall...

    Chassis braces from thetoyz add a lot to overall stiffness of the truck. While placing an order you could also look for Aluminum Steering Arm Post...
  10. Thread: Mudding!!!!

    by zach23
    Replies
    35
    Views
    625

    To me sounds like you might have a lot of...

    To me sounds like you might have a lot of rust/dust/sand everywhere. I think that general maintanace with total teardown, cleaning and lubrication should be the cure.
  11. Thread: Mudding!!!!

    by zach23
    Replies
    35
    Views
    625

    But you can! The truck needs to be prepared and...

    But you can! The truck needs to be prepared and maintained properly afterwards. look for waterproofing and you'll find tons of threads including film, pictures, tutorials etc. Check youtube as well -...
  12. Replies
    6
    Views
    170

    all 1/16 scale and big Revo are in a single...

    all 1/16 scale and big Revo are in a single "mode", but I have only one traxxas vehicle, so cannot test it

    http://freeimagehosting.nl/site2/image.php?di=ALGE
  13. Replies
    6
    Views
    170

    Try resetting first - if that is the transmitter...

    Try resetting first - if that is the transmitter you have:

    http://traxxas.com/sites/default/files/6507-6508-6509-TQi-Manual-120130.pdf
  14. Thread: Mudding!!!!

    by zach23
    Replies
    35
    Views
    625

    I vote also for the bearings. Leaving such...

    I vote also for the bearings.

    Leaving such mess overnight to dry wasn't the best idea I'm affraid. Always blow as much water after cleaning as possible to prevent rust. Compressed air is very...
  15. Replies
    15
    Views
    431

    The only thing I've broken so far is a front...

    The only thing I've broken so far is a front a-arm after head-on collission with a tree. Strange that I noticed it only when batteries went dead and the plastic was holding only on tiny bits and some...
  16. Replies
    9
    Views
    122

    throttle should work without any problems. If it...

    throttle should work without any problems. If it does after unplugging the servo, it only confirms that you need a new servo.
  17. Replies
    9
    Views
    122

    You mean with servo connected or disconnected?

    You mean with servo connected or disconnected?
  18. Replies
    9
    Views
    122

    Can you move the front wheels left and right?...

    Can you move the front wheels left and right?
    Nevertheless unplug the servo from the receiver and check if throttle is working. Most probably that is the cause.

    Those servos have a bad reputation...
  19. Thread: rear wheels

    by zach23
    Replies
    7
    Views
    140

    You need to experiment and find your best setup -...

    You need to experiment and find your best setup - extend of toe-in and toe-out. I don't have a photo at hand at the moment, but mine is about few degrees only - it is enough to keep the truck...
  20. Thread: rear wheels

    by zach23
    Replies
    7
    Views
    140

    This is just how it should be. Front a little...

    This is just how it should be. Front a little outwards and rear a little inwards to ensure stability when going in streight line. You can experiment with different sutup options to suit your driving...
  21. Replies
    3
    Views
    146

    AFAIK it's the same as #7105 only the radio has...

    AFAIK it's the same as #7105 only the radio has single knob. Consider brushless 7107 or 71074.

    5 digit numbers ending with ...4 mean new downgraded radio system. If you like the look of mini revo,...
  22. Check these places first: - knuckle bearings -...

    Check these places first:
    - knuckle bearings
    - stub axles
    - wheel hexes
    - push rods and steering links - if still original replace with new with steel hollow balls (instead of plasic) or...
  23. external "Lipo monitor and buzzer" is a small and...

    external "Lipo monitor and buzzer" is a small and useful little gadget. With it you could use your 2s packs without any problems.
  24. It's funny that each owner of traxxas 1/16 knows...

    It's funny that each owner of traxxas 1/16 knows about servo issues. Either upgraded already or waiting for it to fail. My green 390 should be here today. Together with BB priseweise it cannot be...
  25. Thread: 1/16 Mini Emaxx

    by zach23
    Replies
    211
    Views
    12,121

    simply mind blowing build!

    simply mind blowing build!
Results 1 to 25 of 166
Page 1 of 7 1 2 3 4