Search:

Type: Posts; User: gabrill

Page 1 of 4 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    2
    Views
    238

    If it makes you feel any better, the bulkheads on...

    If it makes you feel any better, the bulkheads on the Revo are MUCH easier to replace than those on the T-Maxx.
  2. Replies
    5
    Views
    330

    There you go, Misbehavin'. Now all the ocd's out...

    There you go, Misbehavin'. Now all the ocd's out there are going to start the whole "required dead shorting" mess again, just because you said it was possible to to have a minor memory affect.
    ...
  3. Replies
    17
    Views
    953

    How cool is that? A 1/10 scale dog!

    How cool is that? A 1/10 scale dog!
  4. Thread: BoUnCiNg REVO

    by gabrill
    Replies
    5
    Views
    404

    Check to see if your shocks have oil in them. ...

    Check to see if your shocks have oil in them. Try 40 or 50 weith to reduce bounciness.
  5. Replies
    9
    Views
    472

    Yes, bigger tires can put more load on the...

    Yes, bigger tires can put more load on the clutches. The slipper clutch is adjusted by tightening or loosening the nut on the spur gear. It shouldn't spin very much while you drive. It should be...
  6. Replies
    13
    Views
    850

    The original T-Maxx had very soft suspension out...

    The original T-Maxx had very soft suspension out of the box, too. You can help the rear-dragging by moving the shock-rods to the inner postion, which is the recommended way to raise the ride hight....
  7. Replies
    5
    Views
    330

    Assuming you're talking about the revo receiver...

    Assuming you're talking about the revo receiver pack, then no. It's a NiMH battery, which is recommended to store with some charge in it.
  8. Replies
    7
    Views
    410

    Cast pieces are poured into a mold, like plastic...

    Cast pieces are poured into a mold, like plastic or ceramic. They have uneven strength across the part because of the way they cool. Machined pieces are cut down from a single solid ingot or bar,...
  9. Replies
    10
    Views
    244

    I've noticed quite a bit of variance depending on...

    I've noticed quite a bit of variance depending on where I point my infrared temp checker (radio shack). My best results come from pointing the sensor BESIDE the glow plug, not on it. Also, 3 high...
  10. Replies
    10
    Views
    244

    What's your temping method and outside...

    What's your temping method and outside temperature?
  11. Replies
    6
    Views
    573

    How odd. I've race mine on some pretty rocky...

    How odd. I've race mine on some pretty rocky tracks, and the skids seam to have plenty of life left. I just placed 2nd in the Arkansas points series Race#2 *very big grin*. I didn't place so well...
  12. Thread: what yo get?

    by gabrill
    Replies
    5
    Views
    301

    PoRT55, I don't think you read my reply. I've...

    PoRT55, I don't think you read my reply. I've answered your questions already.
  13. Replies
    6
    Views
    573

    what kind of wreck does it take to kill the...

    what kind of wreck does it take to kill the plastic skids? I've never broken one.
  14. Thread: what yo get?

    by gabrill
    Replies
    5
    Views
    301

    Congrats! Break in with the pipe you're...

    Congrats!


    Break in with the pipe you're going to run. It won't make a difference to the engine, but since tuning is the final step of break-in, it's best to do the process with your running...
  15. Replies
    11
    Views
    284

    A very small dab of threadlock or RTV sealant may...

    A very small dab of threadlock or RTV sealant may help you.
  16. Replies
    12
    Views
    396

    A much better body part is the tip of your...

    A much better body part is the tip of your closed-toe sneakers. At least they're designed to take a beating. Really, I've never had problems restarting a TRX engine after stuffing the muffler. ...
  17. Replies
    16
    Views
    572

    No, ktiller is talking about the gasket that...

    No, ktiller is talking about the gasket that seals the metal backplate on the crankcase.
  18. Yes, loosening the slipper will releive stress...

    Yes, loosening the slipper will releive stress from the driveline, if you do it properly. You want it to be just tight enough to "chirp" the tires on whatever surface your running on. If it does...
  19. Thread: Help!!

    by gabrill
    Replies
    24
    Views
    263

    I would check a few things things. The cross pin...

    I would check a few things things. The cross pin that holds the driveline to the transmission if that is missing, then you will get weak power to that wheel. Next check the diff bearing on the left...
  20. Replies
    4
    Views
    235

    The skid plate holds the bottom on, and the tower...

    The skid plate holds the bottom on, and the tower holds the top one on. RPM is the best on the cheap, and then stock.
  21. Replies
    6
    Views
    529

    Really, if that's the case, then get you some...

    Really, if that's the case, then get you some cheap new stock wheels off of ebay. They should have plenty of grip in the grass.
  22. Replies
    29
    Views
    1,773

    I know the center diff needs the one way...

    I know the center diff needs the one way conversion and and rear brake module to work well. Are there any other purchases needed when installing on an older Revo 2.5 basic?
  23. Sorry, no. The cradle is also attached to the...

    Sorry, no. The cradle is also attached to the center channel, and will not come loose that way.
  24. Replies
    4
    Views
    257

    Have you thought about offering to start an EU...

    Have you thought about offering to start an EU manufacturing plant and DC for them?
  25. Replies
    12
    Views
    547

    I'm confused as to why you think 2wd will be...

    I'm confused as to why you think 2wd will be better for dunes? Not only will you lose half of your pulling meats, but the Revo is balanced for 4wd, and that will work heavily against you. Heavy...
Results 1 to 25 of 76
Page 1 of 4 1 2 3 4