Search:

Type: Posts; User: Riverbluff

Page 1 of 3 1 2 3

Search: Search took 0.11 seconds.

  1. Replies
    11
    Views
    1,116

    My slayer also drifts to the left when it hits...

    My slayer also drifts to the left when it hits second gear when accelerating hard on pavement, but if you accelerate a bit slower or get used to when it is going to shift, it's controllable.

    +1 on...
  2. Replies
    7
    Views
    369

    I have the slayer pro and love it. It is a very...

    I have the slayer pro and love it. It is a very well built truck. With a few hop ups it is pretty stable. Highly recommend that you put the sway bars on it. That helps a lot. I would really like...
  3. Replies
    0
    Views
    145

    Any Nitro SC racing in/near Tucson Az?

    I just recently relocated from Germany to Tucson Az and I am interested in finding a track to race at. Does anyone know of a nitro track in or around Tucson? I want to start racing my Slayer and...
  4. Replies
    17
    Views
    1,215

    You will need to buy the rear brake kit. The...

    You will need to buy the rear brake kit. The front disk will stay where it is at and then the rear kit goes on the back side of the trans.
  5. Replies
    3
    Views
    253

    My 3.3 (and 2.5) were both dreams to break in. ...

    My 3.3 (and 2.5) were both dreams to break in. Both started up no problem and I am still running the original glow plug in both after about 1 gallon of fuel in each.

    They are both touchy when...
  6. Replies
    9
    Views
    1,170

    Mis-print I think. I installed it on my slayer...

    Mis-print I think. I installed it on my slayer pro with no issues at all.

    Bill
  7. The rear brake is different. It is actually made...

    The rear brake is different. It is actually made up of 2 fiber discs sandwiched between 3 metal plates.

    I was very surpriced at how well the truck stops with the rear brake added.

    Bill
  8. Replies
    2
    Views
    175

    It does not eliminate the slipper clutch. The...

    It does not eliminate the slipper clutch. The center diff replaces a gear in the transmission (The stock gear is a solid link between the front and rear drive shafts).

    Bill
  9. I noticed a big difference with drivability after...

    I noticed a big difference with drivability after I installed the CD and rear brake kit. Braking is greatly improved as well.

    Super easy to install. Only took me about one hour.

    V/R
    Bill
  10. Replies
    3
    Views
    536

    I would stick with just a single steering servo,...

    I would stick with just a single steering servo, as long as you are using a hitorque servo you'll be fine. The REVO and Slayer Pro use the same chassic, that is why there a spot for a second...
  11. Replies
    8
    Views
    689

    It seems strange that it is still cutting in and...

    It seems strange that it is still cutting in and out after swapping Tx and Rx. Did you use the same servos? There could be a problem with one of them, I have seen that happen befor with airplanes.
  12. Replies
    9
    Views
    526

    My 5 cell pack usually takes about 3 hours to...

    My 5 cell pack usually takes about 3 hours to fully charge, Most chargers have a light that will either change colour or stop blinking once sharging in complete.
  13. No, it doesn't make a difference. For the high...

    No, it doesn't make a difference. For the high side needle, you are looking down at it and for the low side, you are looking at it from only one side anyway.



    The sift point is set in the...
  14. Replies
    13
    Views
    763

    And super easy to change, I did a center diff...

    And super easy to change, I did a center diff install with a rear brake kit all in under 45 minutes.
  15. Replies
    13
    Views
    763

    Seems there are a few of us in Germany, I'm at...

    Seems there are a few of us in Germany, I'm at Ramstein...
  16. Recommend checking your mesh between the spur...

    Recommend checking your mesh between the spur gear and the clutch bell. Also check that your transmission is running smoothly. How tight is your slipper clutch set. Might try loosing it up a bit...
  17. Replies
    13
    Views
    698

    Could be your HSN and/or LSN are a bit to lean as...

    Could be your HSN and/or LSN are a bit to lean as well. Recommend that you take note of where the settings currently are and then richen up the HSN or LSN a bit (only do one at a time though) and...
  18. Replies
    3
    Views
    243

    Tuning is really a there step process. Idle...

    Tuning is really a there step process. Idle speed, High side needle and low side needle. 275-280 is way to hot so it is too lean. Sluggish on takeoff can still be atributed to the LSN. If it is...
  19. Thread: I'm Dead...

    by Riverbluff
    Replies
    63
    Views
    3,716

    The Traxxas radios (at least all of the ones I...

    The Traxxas radios (at least all of the ones I own) do not have a failsafe built in. My Airtronics does though. If I loose signal the steering goes straight and the brakes are applied. Of course...
  20. Thread: I'm Dead...

    by Riverbluff
    Replies
    63
    Views
    3,716

    If it wouldn't respond to inputs, that means you...

    If it wouldn't respond to inputs, that means you have a radio problem. A fail safe would have solved the problem.

    Do not trust the radio you have installed. If it failed once, it will fail...
  21. Thread: I'm Dead...

    by Riverbluff
    Replies
    63
    Views
    3,716

    I would suspect that you had a battery (Rx or Tx)...

    I would suspect that you had a battery (Rx or Tx) go bad. Truck doesn't look to bad (as log as chassis didn't get bent). Too bad to hear about the garage door though.
  22. Replies
    10
    Views
    1,143

    OS makes a direct fit .21TM engine. Tower...

    OS makes a direct fit .21TM engine. Tower Hobbies Part #LXRTM2.

    That being said, the TRX 3.3 is a great motor. Follow the breakin procedures and it should give you plenty of performance. I have...
  23. Center Diff and Rear Brake Kit Ops Check

    Finally got a chance to run the truck with the center diff and rear brake kit. Made a big difference in driving and stopping. Having the second brake really makes it stop. I need to back off some...
  24. Changing it to later will not affect top speed. ...

    Changing it to later will not affect top speed. It will just go to a higher RPM in first before it shifts. The biggest thing to look at is how it reacts when it shifts into second. If it looses a...
  25. Seems like it is fine. Might be shifting a bit...

    Seems like it is fine. Might be shifting a bit early, but that is really a drivability question for you. If you're happy with the way it drives I'd leave it where it is.
Results 1 to 25 of 69
Page 1 of 3 1 2 3