Search:

I really considered that motor last month but hobbypartz increased their shipping prices. $30 to canada for that motor only and i cant really spend that much.

Thanks pete. I hope you'll give me...

Hey guys, I just bought this combo under $100. Wondering if it will be a lot better than my Sidewinder SCT combo because the motor just won't cut it. The motor gets hot at 15/54 after a full pack of...

Seems that my cheap $10 48pack AA batteries are the problem. I put Duracell with 1.605V in each and problem solved. Thank Jimmie.

my radio and receiver are acting weird. here are the problems.


when i turn on the tx it just blink green. i tried adjusting the mulifunction knob but it doesnt stop.
i followed the binding...

They are dogbone style which doesn't require extra cleaning. MIP requires grease in their splines to perform well which will attract more dirt. Tekno are lighter. You'll get beefy hub carriers and...

Clean and re-lube bearings. Clean the differentials with degreaser/contact cleaner then apply automotive grease. Silicon or Lithium based. Take your time to dismantle all of the parts mostly plastic...

Tekno is a less expensive option. I like better the design over MIP. They are $36-40 on eBay.

Here's mine. No problems on them so far.
http://img9.imageshack.us/img9/2660/img2178cropped.jpg

hidden $20 fee for castle esc's?

Running in 2WD truck is easier for the motor to work. 4WD is times two the load. 17T pinion is for speed runs only.

Novak Steel Pinion Gear 5mm 32P 12T/13T/14T 3-Pack

http://pics.towerhobbies.com/image/n/novc5160.jpg

bumped! Anyone out there?

Help me with the stock lengths of turnbuckles for the P4de measured from center to center.

FRONT
cambers =
turnbuckles =

REAR
cambers =

Yeah. I dismantled it yesterday and I did what you just said. Its still wobbling(a little bit). But when I run it wheels off the ground, I can't see so much wobbling. I'm getting a threadlock 2mo....

Its my first time to take apart the rear assembly. The center drive shaft and slipper clutch is now wobbling after I did the "electrical tape mod" to seal the drive shaft at the servo area. Then I...

will this fit for the Pede 4x4? TRA3822 heatsink for 540 motors

http://www3.towerhobbies.com/cgi-bin/WTI0001P?I=LXJD94&P=8
...

Yeah its just a toy. I'll be messing with my toe ins now.

i measured each turnbuckle in between and they have the same offset, 36mm. when aligning, is it important to match each turnbuckle's offset or can i just adjust them till its straight track?

i did loosen the screw and re-center the servo horn but i couldn't. the next tooth is more to the left again. can adjusting the push rod(highlighted area) solve the alignment?
...

so can i adjust the push rod/steering link at the servo arm?

should i match the length of each turnbuckle or just randomly adjust each one of them till the track is straight?

so i won't touch the push rod connected to the servo arm?

ok i'll try it.

is servo arm is also called servo horn?

hmmm i did that 1st solution you said a while ago. i had no luck. can i adjust the push rod of the servo arm?

i have a p4de stock out of the box. 1 day old. when i turned it on for the 1st time and put some throttle, the wheels are wobbling.

also i noticed that the front wheels are slightly turned right...