Search:

Type: Posts; User: pntmachine

Page 1 of 20 1 2 3 4

Search: Search took 0.45 seconds.

  1. Replies
    14
    Views
    326

    That is not from a wreck that is torque twist. It...

    That is not from a wreck that is torque twist. It happens to us a lot in racing especially here in Florida where we run mostly blue groove or high bite tracks. Only choice is to replace them. They...
  2. I don't think there is anything you will gain...

    I don't think there is anything you will gain from turning the pillow balls. With as much as can be taken off the ackerman done and stops removed there is no more travel left even if the balls were...
  3. I have raced RD carriers for years and they are...

    I have raced RD carriers for years and they are already have more travel than any carrier produced. Mine turns rack to rack with no problems and are already bevel cut in that area. They have as much...
  4. Replies
    3
    Views
    177

    You are going to be fine. 240 is not that hot,...

    You are going to be fine. 240 is not that hot, 280 and up is.
  5. Replies
    18
    Views
    511

    It may be flooding out. Return it to factory...

    It may be flooding out. Return it to factory settings as said. If it is a broken in motor take the high speed to about 3 and 1/2 turns. Then lean the bottom a little at a time until it pops and fires...
  6. Replies
    12
    Views
    505

    The extended chassis is just the stock 3.3...

    The extended chassis is just the stock 3.3 chassis and nothing else. That term was actually from the early days when we were racing the 2.5 chassis. They were extending that chassis then and it just...
  7. Check the output shaft pin in the forward gear....

    Check the output shaft pin in the forward gear. Sometimes it snaps inside and cannot be seen when you just look inside the tranny.
  8. Replies
    10
    Views
    340

    You may have sheared the pin in the forward gear...

    You may have sheared the pin in the forward gear of the output shaft.
  9. On adjustment to the servos on a dual setup the...

    On adjustment to the servos on a dual setup the servos do not end up at rest being at 90 degrees, they both should end up off center slightly.
  10. Replies
    3
    Views
    154

    The Center Diff Kit comes with the FOC. They are...

    The Center Diff Kit comes with the FOC. They are in contact with each other so the FOC has to be used.
  11. Replies
    41
    Views
    4,031

    There is no doubt mixing two fuels should not be...

    There is no doubt mixing two fuels should not be an issue but look at the oil/synthetic ratio and not the nitro content and tune accordingly. Think about mixing a fuel that could have 9 percent lube...
  12. Replies
    19
    Views
    912

    Here is an overhead shot to show some comparison...

    Here is an overhead shot to show some comparison as well. I have a Lot!!! of tires new and barely used.
    http://i181.photobucket.com/albums/x194/pntmachine/100_3697.jpg
  13. Replies
    19
    Views
    912

    If you are track racing with a Revo then half...

    If you are track racing with a Revo then half offsets are the way to go. The truck is much more stable with the wider stance of the offset wheels. The bearings were never affected much for me but I...
  14. Replies
    4
    Views
    264

    The rod material was never made into threads...

    The rod material was never made into threads that I know of because they are tubes. The first make of these were permanently fixed and would snap so they made the removable threaded ends. You can...
  15. Replies
    8
    Views
    359

    The Blue and Silver springs are made for the LT...

    The Blue and Silver springs are made for the LT Rockers. That is why they are shorter than the other springs.
  16. Replies
    12
    Views
    844

    The receiver box is off a Platinum Edition but I...

    The receiver box is off a Platinum Edition but I modified it by adding a charge port on top. I cut it out of another style receiver box(don't remember which), ground it down and installed it in the...
  17. Replies
    12
    Views
    844

    LOL. not much anymore. Believe it or not that is...

    LOL. not much anymore. Believe it or not that is a pic at the races, thats why the tires are looking new. A little simple green and air gun after the qualifiers and it was ready to go. Now its a...
  18. Replies
    2
    Views
    181

    The real problem with these is that the pin...

    The real problem with these is that the pin starts wearing the slot out and trapping the pin in the slot. Its a fight to get off but if you work at it long enough it will probably come off.
  19. Replies
    12
    Views
    844

    I have a bunch of new ones for cheap if you want...

    I have a bunch of new ones for cheap if you want to try some. PM me.
  20. Replies
    12
    Views
    844

    So does my Kyosho STRR yet I run two externals.

    So does my Kyosho STRR yet I run two externals.
  21. Replies
    12
    Views
    844

    I always used one on all my vehicles racing and...

    I always used one on all my vehicles racing and never had any air leaks. It will also allow you a little more time upside down should you need it. I used a Mugen filter.
    ...
  22. Replies
    3
    Views
    213

    Racing I always used Hitec 7955 for steering but...

    Racing I always used Hitec 7955 for steering but in Truggy I raced with Savox SC1256TG for steering and SC1257TG for throttle and they have worked very nice for less money.
    ...
  23. Replies
    22
    Views
    1,012

    I would not seal a Traxxas motor, its just one of...

    I would not seal a Traxxas motor, its just one of those motors that does not need to be. If the motor is sucking air its usually a front bearing. In this case very unlikely.
  24. Replies
    6
    Views
    386

    The E Revo diffs are a much better and more...

    The E Revo diffs are a much better and more durable diff. There is three differences, one is the I Beam which I did not use in racing because I liked to have more room for diff fluid. The more...
  25. Replies
    9
    Views
    463

    The extended arms give a 19mm increase. The 3.3...

    The extended arms give a 19mm increase. The 3.3 chassis has a 30mm increase.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4