Search:

Type: Posts; User: mef_cz

Search: Search took 0.00 seconds.

  1. Replies
    9
    Views
    1,050

    I tried solution with zipties. If it will work...

    I tried solution with zipties.
    If it will work and setup will not be worse, throw winter I will try make better solution, that will be acurate to set up....
  2. Replies
    9
    Views
    1,050

    Hmm, but this still leave stress on rod ends. I...

    Hmm, but this still leave stress on rod ends. I dont want use metal rod ends, becouse is better to change plastic rod end then change other parts.... thank you for picture.
  3. Replies
    9
    Views
    1,050

    Could you post some pictures, how you ziptied...

    Could you post some pictures, how you ziptied front rockers?
  4. Replies
    9
    Views
    1,050

    I tried it glue and it did not help. Two of...

    I tried it glue and it did not help.
    Two of problems was on steel pushrods nad two was on aluminium pushrods.
  5. Replies
    9
    Views
    1,050

    pulled rod end from pushrod

    Hello,
    on our last race, we had problems with four rodends (2 traxxas nad 2 rpm) whiw were pulled out from pushrods.
    Allwas it was after bad landing, when car landed on chassis and wheels went...
  6. Replies
    14
    Views
    1,293

    I am sorry, I was busy at work. refilled dampers...

    I am sorry, I was busy at work.
    refilled dampers and revised long of pushrods solved my problem.
    But erbe was nervous and still turned, but not to only one side.
    So I changed front spring for...
  7. Replies
    14
    Views
    1,293

    I tryed simple think. On the ground I lifter rear...

    I tryed simple think. On the ground I lifter rear of erbe in the center and LR wheel stayed on the ground little bit longer. So I put RR pushrod to the inner hole on arm......and erbe become turning...
  8. Replies
    14
    Views
    1,293

    May be. I will try. I have diff to change. But...

    May be. I will try. I have diff to change. But "on table" it looks like good.
    And what about different lenght of rear ampers or pushrods and different droop on rear arms?
  9. Replies
    14
    Views
    1,293

    Bearing are good. Without throttle it stay...

    Bearing are good.
    Without throttle it stay straight. It turns only on hard brakes.
  10. Replies
    14
    Views
    1,293

    Turning to left on brakes

    Hello,
    I have problem with my erbe.
    I niticed problem on last race. When I brake very hard, my erbe wants turn to the left. Always to the left.
    I tested it on asphalt too. It is tha same. When...
Results 1 to 10 of 10