Search:

Type: Posts; User: Jack@HPL

Page 1 of 5 1 2 3 4

Search: Search took 0.11 seconds.

  1. Replies
    6
    Views
    386

    soooooooo......how much? :)

    soooooooo......how much? :)
  2. Replies
    9
    Views
    588

    no unlocking on an XL2....and with a 750kv you...

    no unlocking on an XL2....and with a 750kv you will go slower....less KV equals less RPM at a given voltage.
  3. Replies
    49
    Views
    2,973

    nice!>...350.00 bux is a great price!......but...

    nice!>...350.00 bux is a great price!......but too bad it wont hold an XO-1.....its too narrow... ...I like the OP's dyno though!....it looks so scale!
  4. Replies
    46
    Views
    2,487

    im in for a south florida meet.

    im in for a south florida meet.
  5. Replies
    49
    Views
    2,973

    I need one of these for my shop!... Illl put...

    I need one of these for my shop!...

    Illl put it right next to my full sized dyno...
    ...
  6. Replies
    17
    Views
    973

    looks nice.....as long as you keep her arrow...

    looks nice.....as long as you keep her arrow straight you wont have an issue...but any steering input at speed and that high CG will likely make it roll.
  7. richen the high needle...

    richen the high needle...
  8. Thread: jato rolling

    by Jack@HPL
    Replies
    6
    Views
    301

    this sounds like you are having a tune...

    this sounds like you are having a tune issue...when you say it wont stay running will it stay running once it is rolling?...under throttle?...or is it just stalling at idle?.....
  9. Replies
    15
    Views
    1,031

    a well tuned 3.3 is the best bet for you....I...

    a well tuned 3.3 is the best bet for you....I have 3.3's in my Jato and Tmaxx...both will wheelie on demand in first AND second gear.....(with proper gearing)
  10. Replies
    6
    Views
    295

    if the receiver on/off switch is in the off...

    if the receiver on/off switch is in the off position NO POWER should be getting to the receiver....a bare spot on the antenna wire would not give the servos power....you must have an internal short.
  11. Replies
    6
    Views
    425

    buy a small air compressor and blow it off after...

    buy a small air compressor and blow it off after rinsing with soapy water.
  12. Replies
    6
    Views
    859

    Garmin Forerunner 101

    Garmin Forerunner 101
  13. Replies
    3
    Views
    549

    Stock Traxxas 3.3....

    Stock Traxxas 3.3....
  14. Replies
    3
    Views
    549

    Drag Jato's...Whos the quickest?

    I have run multiple 2.4 sec passes in 132ft. heres a picture of my best to date.

    http://i15.photobucket.com/albums/a367/BoostCrzy/739672B0-54A7-4675-B465-BE7251E4F8E0-3347-00000185C32F77F8.jpg
    ...
  15. Thread: Gps

    by Jack@HPL
    Replies
    7
    Views
    783

    I have a Garmin Forerunner 101 and a bushnell...

    I have a Garmin Forerunner 101 and a bushnell Radar to back up....
  16. Replies
    18
    Views
    3,912

    thanks....and just for your info....Gyros for...

    thanks....and just for your info....Gyros for Heli work exactly the same as gyros for cars....but some models/brands are higher quality and offer more sensitivity/features such as heading hold...
  17. Replies
    7
    Views
    627

    did you mount these tires and balance them...

    did you mount these tires and balance them yourself?....I see the wheel is broken...perhaps it was cracked from a wreck?...how many tires have you been through?..
  18. Replies
    18
    Views
    3,912

    yea....I think you arent noticing that the funny...

    yea....I think you arent noticing that the funny car servo is a micro servo and not digital.....lol...

    ...The Futaba GY401 is one of the BEST gyros in the world...it has adjustable...
  19. Thread: my 130mph xo1

    by Jack@HPL
    Replies
    12
    Views
    979

    todays access to technology leaves no excuse for...

    todays access to technology leaves no excuse for not properly documenting a claim.....I have a radar gun....GPS..AND..video camera...used together there is no room for challenge. Without it you will...
  20. Replies
    18
    Views
    3,912

    I tried using my GY401 gyro already but the servo...

    I tried using my GY401 gyro already but the servo cant keep up....so you will need a VERY high speed servo to work well using a gyro....otherwise it just twitches into an oscillation as it...
  21. Replies
    18
    Views
    3,912

    just down the road.....fastest in 132ft was 66...

    just down the road.....fastest in 132ft was 66 mph so far.....it should go 70mph plus in 132ft tho on a good run now.
  22. Replies
    1
    Views
    387

    Jack's XO-1....

    Picked up an XO-1 to have some fun making speed runs....stay tuned for updates as she goes faster and faster!!.....my goal is to see just how fast I can make it go on 6s...then who knows!
    ...
  23. Replies
    25
    Views
    5,801

    I put headers on....love it! ...

    I put headers on....love it!

    http://i15.photobucket.com/albums/a367/BoostCrzy/IMG_1737_zpsba064a6c.jpg

    http://i15.photobucket.com/albums/a367/BoostCrzy/IMG_1738_zps410fdeb9.jpg
    ...
  24. Replies
    7
    Views
    2,788

    oh man those bodies would be nice!....but I would...

    oh man those bodies would be nice!....but I would wreck it in seconds....lol...
  25. Replies
    3
    Views
    803

    pros: Its a dragster! Scale dimensions fast in...

    pros:
    Its a dragster!
    Scale dimensions
    fast in a straight line
    a real handful to control(realistic)
    very addicting!

    Cons:
    Its a dragster!
    Scale dimensions
Results 1 to 25 of 124
Page 1 of 5 1 2 3 4