Search:

Type: Posts; User: THEMANRACING

Page 1 of 4 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    21
    Views
    866

    I see how it is now! I help you with the car,...

    I see how it is now! I help you with the car, and then you don't even invite me to go bashing with you...lol
  2. Ok well here is a story just for fun. I should...

    Ok well here is a story just for fun. I should most likely post this in the revo section, as it is a bit dead in there and I would be embarrassed in front of less people, but I was driving the slash...
  3. Replies
    21
    Views
    866

    Glad you are back up and running Boss :) It was...

    Glad you are back up and running Boss :) It was fun and a bit of a challenge to do it over the phone, especially with my Oklahoma accent and you're New jersey accent :) Thanks for putting up with me...
  4. Replies
    18
    Views
    376

    You think a VW with a 454 would not be an...

    You think a VW with a 454 would not be an enjoyable ride? Sounds like low 9's or high 8's to me :)
  5. Replies
    18
    Views
    376

    I don't understand what you mean, you don't agree...

    I don't understand what you mean, you don't agree with replacing the motor and ESC because they are really well engineered.

    That makes no sense to me. If people want to put small block chevys...
  6. Replies
    18
    Views
    376

    I cannot understand how you have not broken a...

    I cannot understand how you have not broken a driveshaft on 3S.
  7. Broke something new and exciting, well for me anyway...

    I blame the people who MADE me wheelie my Slash...lol

    I thought I broke the rear diff as it started driving really odd. Turns out it freaking stripped (I guess rounded would be more accurate)...
  8. Replies
    8
    Views
    184

    You are correct. the True track lower and carrier...

    You are correct. the True track lower and carrier set the toe angle, and it's non adjustable.

    The ball pivot on the upper a arm controls the camber, which will be there with an rpm arm or a...
  9. Replies
    8
    Views
    184

    Out of curiosity why would you want to run the...

    Out of curiosity why would you want to run the stock upper arm?
  10. Replies
    16
    Views
    447

    I have the Traxxas CVD's. Once I got the 2200...

    I have the Traxxas CVD's. Once I got the 2200 motor installed and ran 3S I broke the rear drive shafts in under 5 minutes.

    Replaced them with the CVd's and immediately broke a front...lol ...
  11. Replies
    1,494
    Views
    133,371

    What do you do to get the moving shots? Another...

    What do you do to get the moving shots? Another RC?

    I am just shocked you actually drive it, you have a ton of time and I assume money in it. It freaking looks beautiful, as odd as that sounds....
  12. Replies
    37
    Views
    555

    I figured it out :) I had only run the...

    I figured it out :)

    I had only run the trenchers once, and i guess they were either not broken in, or i did not give them ample opportunity to clean the dirt off the treads before i tried to do...
  13. Replies
    37
    Views
    555

    I have the clutch locked down like it's in...

    I have the clutch locked down like it's in solitary confinement...lol

    Wonder if i just need to try the other spur gear that came with the truck?

    Ow, and just so we are clear.....

    I...
  14. Replies
    37
    Views
    555

    Same as you I believe. I have the sidewinder kit...

    Same as you I believe. I have the sidewinder kit from Castle. Basically the same motor as is in my Revo.

    It is pretty darn quick on 3S.
  15. Replies
    37
    Views
    555

    Well I just bought a set of trenchers for my...

    Well I just bought a set of trenchers for my Slash. I had seen a vid of a Slash doing wheelies and I thought these would help me do the same :(

    Lol on 3S they just spin a lot. I have had really...
  16. Replies
    6
    Views
    349

    What ever you do, DO NOT DRIVE IT!!! It is...

    What ever you do, DO NOT DRIVE IT!!!

    It is more addictive than crack...lol
  17. Replies
    10
    Views
    435

    Those things look BEAST.

    Those things look BEAST.
  18. Replies
    10
    Views
    435

    I have the traxxas steel shafts. If I had...

    I have the traxxas steel shafts.

    If I had to do it over I would find a steel shaft without the dob bone set up. Something with a CV joint.
  19. Replies
    11
    Views
    298

    I am a motorcycle guy :)

    I am a motorcycle guy :)
  20. Replies
    11
    Views
    298

    04 ZRX1200 with a full exhaust and jet kit and...

    04 ZRX1200 with a full exhaust and jet kit and air box mods = 130 RWHP
  21. Replies
    21
    Views
    866

    I believe we got his revo back going. ...

    I believe we got his revo back going.

    Cannot wait till his post.
  22. Replies
    11
    Views
    298

    04 zrx1200? If so great bike. I am not...

    04 zrx1200? If so great bike.

    I am not much help. I have the Trencher x's and also run on pavement, but have yet to damage a diff.

    I have pro line road rage tires as well, and on...
  23. Replies
    24
    Views
    594

    Well of course...lol Why would they give me the...

    Well of course...lol Why would they give me the parts needed to actually make it work the first time!! I will see if the LHS has them, thanks for the help.
  24. I have the same setup. Only problems I have had...

    I have the same setup. Only problems I have had really are breaking the stock axle's. Replaced them with the Traxxas CVD's and no more problems.

    Well ok, I crash it a BUNCH more now...lol
  25. Replies
    24
    Views
    594

    I run the drive cups that came with the...

    I run the drive cups that came with the axle's.... Wrong one's?
Results 1 to 25 of 79
Page 1 of 4 1 2 3 4