Search:

Having literally just done a new clutch... can someone tell me how you generally go about putting that spring on there?

I tried a couple different things, and then just ended up hooking it, and...

YES, you can use your other radio. BUT FIRST... where the micro servo connects to the tranny, by a rod... pin that rod in place so that an accidental impact doesn't shift your truck.

Otherwise,...

Does it still work fine in reverse? Then your transmission is stuck in second gear. Move the adjuster towards " Shift sooner" which I recall as being full left. Full left should stick the trans...

You say you checked the reverse servo? When it moves, it pulls a little pin in or out of the transmission. So switch it, and wait just a second after it stops moving, and give it a little blip on...

Check the orientation of the fuel lines. Are they parallel to the ground? The thing is, it's a gravity/pressure feed system, so when you roll the truck, if the fuel lines aren't flat in relation to...

OK, I have slightly different opinion about your problem.
First, pull off the clutch and look at it closely. Are the shoes ok? Is it all round when you put it together? Is the spring in good...

Oh yeah, if you like grinding stuff, you can go this way too. I'm not a fan personally, but that's because I'm not so good with a moto tool.

Alright, so I just did this for two revo 3.3s. The Ofna Box you want is called T-start. You'll need a couple of 7.2v battery packs. I assume you have that covered.
As for the truck itself, you...

pbflash - I have the same... issue. I have the FOC and Center Diff and can't make my revo wheelie at all. But since it breaks 50mph (clocked by police radar - they thought it was the best toy they...

I converted both my revo trucks to bump start. Ofna makes a bump box called the "t-start" specifically for Revo. No modification of the truck is required. Well, other than ripping off the...

You can pretty easily 'prime' the engine by holding your finger over the exhaust outlet for a second or two while you crank the engine. This should get your fuel system ready to start without having...

I had a very similar problem recently. There was nothing wrong with the servo, it's just that the traxxas throttle horn pivot is a bit dubious. I found a couple of solutions.

First, be 100%...

Is that motor and kit compatible with Bump Start box? Because I really like my bump starter and I don't want to move away from it.

1) OK, I figured it out. Fortunately before I tore apart the drive system. It turns out my cheap as ... well cheap wheels broke. The right rear hex hub is completely stripped out and the axle...

Nice video, nicely done. After some of the crazy things I've seen on youtube for bearing removal/replacement, this video is all anyone should watch.

I do have one question... how long was the...

First, my story. I recently purchased two Revo 3.3's on Ebay. Got a good deal on the trucks and a pile of spare parts. I've been tuning, replacing, tearing down and rebuilding since then.

The...