Search:

Type: Posts; User: Erevojoe

Search: Search took 0.22 seconds.

  1. Replies
    17
    Views
    729

    Crap. I've need through lots of parts in the last...

    Crap. I've need through lots of parts in the last week. I've now replaced two drive shafts, both rear tires and may have to replace one 17mm hex and the nut. Also, do the shock springs “relax" over...
  2. Replies
    4
    Views
    622

    Ok, but I'd still like to know the thread pitch. ...

    Ok, but I'd still like to know the thread pitch. The threads on the hex need cleaned up and I'd rather not guess. I can't find my thread gauge. Thanks
  3. Replies
    4
    Views
    622

    Thread pitch on 17mm hex wheel nuts?

    Anyone know the thread pitch on the 17mm hex wheel nut? I had one come off last night and I wanted to clean up the threads and maybe try I nylock nut. Thanks
  4. Replies
    17
    Views
    729

    Your absolutely right, I was quickly looking over...

    Your absolutely right, I was quickly looking over replays between 2 1/2 hour runs on our production lines and didn't take the time to look it over on a bigger screen. However, my mistake may have...
  5. Replies
    17
    Views
    729

    I was thinking about taping the tires but the one...

    I was thinking about taping the tires but the one of the links showed the tape on the outside. Wouldn't this defeat the purpos of tires? If the tread isn't going to grip the surface, why not run...
  6. Replies
    17
    Views
    729

    Shredded a tire today. No dry rot or anything....

    Shredded a tire today. No dry rot or anything. Does age affect tires like this or am I just too hard on it? Also, I love the stock tires,but is there something better coming on the newer models or...
  7. Replies
    17
    Views
    729

    I never left the batteries for more than six...

    I never left the batteries for more than six months without checking them
  8. Replies
    17
    Views
    729

    Stripped a primary gear, I guess the lash wasn't...

    Stripped a primary gear, I guess the lash wasn't tight enough. Also, my passenger side front wheel stopped spinning for a few seconds, then I tried turning it by hand and it poped back into sync...
  9. Replies
    17
    Views
    729

    Newbie, sort off

    Ok, I bought my erevo brushless about three years ago and ran it for a few months until I broke the upper
    And lower right side control arms. I also lost my job around the same time and just...
Results 1 to 9 of 9