Search:

Type: Posts; User: The Juice

Page 1 of 3 1 2 3

Search: Search took 0.31 seconds.

  1. Replies
    18
    Views
    1,758

    A rock in the driveline?

    A rock in the driveline?
  2. Replies
    3
    Views
    237

    I had them in the right way I just had them...

    I had them in the right way I just had them reversed. One side is barely rounded and that side goes out and smooth is against the gears, I had them reversed. Thanks though.
  3. Replies
    18
    Views
    1,758

    Sounds like your center diff bearing. Mine did...

    Sounds like your center diff bearing. Mine did the same thing, only made noise when it was on the ground. Bearing and cone on the center diff where shredded.
  4. Replies
    3
    Views
    237

    center diff problems

    I had to replace the center diff bearing on my slash so I decided to clean it out and put some different weight oil int. When I put it back together the gears wouldn't turn. When I back out the 4...
  5. Replies
    15
    Views
    1,246

    It could be, but either way it definitely sounds...

    It could be, but either way it definitely sounds related to an air leak.
  6. Replies
    1
    Views
    948

    clutch shoe install

    Can you install the clutch shoes backward on the 3.3? If so how do you know which way is forward?
  7. Replies
    15
    Views
    1,246

    Would that cause the engine to go to max rpm at...

    Would that cause the engine to go to max rpm at start up?
  8. Replies
    15
    Views
    1,246

    I was looking inside the carb and messing with...

    I was looking inside the carb and messing with the idle screw. I noticed the gap wasn't changing no matter which way I screwed it. I screwed it all the way in and it appears its stripped, it just...
  9. Replies
    15
    Views
    1,246

    The carb looks like its in there. Could I have...

    The carb looks like its in there. Could I have messed something up when I put the engine back together?
  10. Replies
    15
    Views
    1,246

    After looking inside the carb it looks like it...

    After looking inside the carb it looks like it normally does when at idle. It moves open fine when I throttle up. What would be causing the motor to rev to the max if the carb is at idle settings?
  11. Replies
    15
    Views
    1,246

    I didnt look inside the carb I was in a hurry to...

    I didnt look inside the carb I was in a hurry to shut it down. I will look at it with the electronics on, that should be the same.
  12. Replies
    15
    Views
    1,246

    Revo revving problem

    I have a Revo with the 3.3 that I got free but in an unknown condition. I got it running pretty well but could never get the idle down. I had a friend trying to get the idle right this weekend and...
  13. Thread: no brakes

    by The Juice
    Replies
    7
    Views
    946

    Its set on the 50/50.

    Its set on the 50/50.
  14. Thread: no brakes

    by The Juice
    Replies
    7
    Views
    946

    With the servo horn off i have normal throttle...

    With the servo horn off i have normal throttle movement but barely any reverse movement on the servo. If I max the throttle trim all the way to the right then there seems to be even movement forward...
  15. Thread: no brakes

    by The Juice
    Replies
    7
    Views
    946

    no brakes

    I have a revo 3.3 with the single brake that's off the transmission. I am not familiar with the way the servo works with the throttle and the brake. When I watch the servo it moves fine for the...
  16. Replies
    12
    Views
    1,098

    Well I got enough out of the way to check the...

    Well I got enough out of the way to check the engine out and it looks ok. I was trying to figure out the receiver battery pack that is installed. I think I read its a 5 cell nimh but does anyone...
  17. Replies
    12
    Views
    1,098

    I was able to get the head off and see inside and...

    I was able to get the head off and see inside and it looks ok as far as I can see but it feels like its stuck and wont spin.

    I didn't get anything with it, not even the transmitter or the...
  18. Replies
    12
    Views
    1,098

    I wish it were that easy. I see the 4 bolts but...

    I wish it were that easy. I see the 4 bolts but the easy start is in the way, the exhaust has to come off, the air filter, the throttle servo linkage has to be disconnected, so far thats all I have...
  19. Replies
    12
    Views
    1,098

    Engine removal

    I inherited a forgot about in the garage Revo 3.3. I want to take the engine out to examine it but cant figure out how. All of the mounting bolts are blocked by something else. Is there an order...
  20. Replies
    19
    Views
    1,504

    Is there any performance gained with the big...

    Is there any performance gained with the big bores or are they just stronger? Do they hold more oil or have stiffer springs?
  21. Replies
    2
    Views
    413

    You are correct on the motor, thanks.

    You are correct on the motor, thanks.
  22. Replies
    27
    Views
    628

    That is not incorrect information. That battery...

    That is not incorrect information. That battery wouldn't fit no matter what way I put the hold down. You might have gotten the bigger strap. The one mine came with is straight across. There are 2...
  23. Replies
    27
    Views
    628

    Thats the maximum, doesnt hurt to go lower it...

    Thats the maximum, doesnt hurt to go lower it just takes longer.
  24. Replies
    27
    Views
    628

    Ouch 90 a piece! Those should work fine. :p

    Ouch 90 a piece! Those should work fine. :p
  25. Replies
    27
    Views
    628

    On my last order I used the cheapest/longest...

    On my last order I used the cheapest/longest method and it took 2.5 weeks I think.
Results 1 to 25 of 56
Page 1 of 3 1 2 3