Tab Content
No Recent Activity

2 Visitor Messages

  1. Hey There EMAXXBRUSHLESS. I fill the diff cup entirely, put in 3 of the screws to about 80% tight, oil should come out of the 4th hole. screw in 4th screw and then all others to 100% tight. Then loosen each screw individually, take screw out and clean hole with an ear bud or cotton bud (not sure what you call them over there). Then loctiite on screw and screw in. Repeat for other 3 screws.
  2. View Conversation
    Hey mugs, Did you come up with any tricks to fill the hr diff cups without the oil running out the holes? They say to loctite the screws. but if the threads are full of oil?
    Im thinking of a pc of tape over the holes to hold the oil in. Then after assembly blow out the thread ends with some cleaner and then a drop of loctite on each to hopfully soak in.
Showing Visitor Messages 1 to 2 of 2
About Mugs

Basic Information

Date of Birth
August 8, 1973 (41)
About Mugs
Location:
BNE
Occupation:
Problem Solver

Signature


Always get a 2nd Opinion!

Statistics


Total Posts
Total Posts
704
Posts Per Day
0.85
Visitor Messages
Total Messages
2
Most Recent Message
02-04-2013 02:39 PM
General Information
Last Activity
02-11-2014 08:25 PM
Join Date
05-14-2012

5 Friends

  1. deadmeat deadmeat is offline

    RC Enthusiast

    deadmeat
  2. EMAXXBRUSHLESS EMAXXBRUSHLESS is offline

    RC Champion

    EMAXXBRUSHLESS
  3. mike-susieq1 mike-susieq1 is offline

    RC Turnbuckle Jr.

    mike-susieq1
  4. MITCH316 MITCH316 is offline

    RC Turnbuckle Jr.

    MITCH316
  5. RC-Fan RC-Fan is offline

    RC Turnbuckle Jr.

    RC-Fan
Showing Friends 1 to 5 of 5