Forum: Traxxas Slash

Alright guys... i need your help on this one. -STRAIGHT TO THE POINT: I'm going to start building a slash that has a lot of scale components ie:...

hi i was just wondering if there is a training mode switch on the slash vxl 2wd?

i bent another stock front hinge pin and nearly broke another rpm arm and almost broke my bulkhead again. i like the stock hinge pins because they...

Warning if you ever buy these, the pins for attaching the knuckle are shorter than the stock one (to short). I had one bend/pull out and now I have a...

I replaced my sons 20 tooth pinion gear with a 19 tooth. He lost a little quickness, but gained top speed. What is the difference if I go from a...

Can anyone tell me the best way to get a stripped pinion gear screw out? I am trying to remove my motor but noticed that my pinion screw is stirpped...

Hey all, I have a Slash 2WD, and I have a problem, everytime I install a new spur gear (90 tooth) it strips..:thumbdown: And I think its my...

I would greatly appreciate if anyone could explain how the tuning of the motor works exactly and what you can tune and why kinda thing. I am a newb...

What is a decent camber setting to run on the front and rear of my slash 2wd for a race. Right now I am sitting around 2.5 degrees negative in the...

hi there, I have a slash 4x4 and run 3cell lipos @ 11.1v and 2cell lipos @ 7.4 v. never had any issues with the ESC. works well with the lipo...

I just finished my first paint job and I got some new wheels and shocks now I need to figure out how to finish it. Should I go with Monster decals or...

Anyone know a good site to have decals made up that are about the same scale as the Slash?

I own a Traxxas Slash 2wd and i was wodering what battery would give me a longer running time. the 8.4 volts 3000mah only last for about twenty...

Hi! What kind of tires are the best for racing on a track? Thanks!

Hey Guys, I picked this up from our local news paper... It's nice to have him here for the third time... It's a huge local event here... ...

whats the part number and size for the wheel hexes on a 2wd slash and what are they for a stampede?

I need a new motor and wanted to know what brushless motor would be the best one would be and want to make sure it will fit. also wanted to know if a...

I did a wheelie and now my car wont drive. I cant even hear the motor. Anyone ever have this problem.

hi guys ! I think i have a problem with my slash, i just bought him yesterday ! i have NIMH batteries in it and the esc is green when a run, i...

Hey I'm new to the RC hobby and my Titan 12t motor has gone to **** again. Anyone out there got any suggestions for a replacement motor? I can't...

I just picked up a rusty vxl . Not sure to keep it as is or take some of the ups out for my slash . It has integy alloy everything lol - with a...

I run my slash when is raining or a wet area(like wet grass)? :confused: The manual say than my slash is waterproof, is really waterproof or i need...

Ok, so I tried to get in and mess with the braking sensitivity on my Slash 2wd. Now I have steering and full throttle but I dont have braking or...

If I have the steering bellcrank that has the servo saver built into it, can I run the aluminum bellcranks that they make for it? After 1 hour of...

Hello everyone, new guy (Scott) here. I have been thinking about getting a Traxxas Slash for a while now...and when the Robby Gordon Edition Slash...

I ran across some cheap street tires on ebay, most say 1:10 car on road rubber tyer plastic rim.....something like that... but 4 tires for $15.00???...

New Slash driver, I had started this hobby with Tamiya rising fighter, then Maverick Strada SC (crap) an after Traxxas Slash 2WD. This truck is huge...

Jumps, bumps and O my. Lol. Stampede and slash's