View Full Version : GPM Tungsten CVD's Install
11-22-2011, 07:27 PM
Hey forum friends,
Just wondering, I got these new tungsten shafts from the Toyz.com, just wondering, I cant seem to make sense of how they hook up to the bulkhead? the original ones had the pin that screws in, but these don't work like that, there is a whole separate peice at that end that seems to have to be installed somhow.
11-22-2011, 09:29 PM
post a pic up bloke! tho i just had a look at them now. hum, nice....?
the installs like the traxxas cvds. open your diff and remove both the gears inside, (not the spider gears in the middle of the diff). remove the outer gears and then the pin behind them, pull out the shaft that is left (has two holes on either end) Fit the gpm cups in the area you just removed the old tiny shaft with two holes on either end,. Install the pin you removed from the old shaft into the new shaft/cups and install the rest the way you pulled it apart. Hope that helps bloke or else im shore traxxas has an online manual for there mini revo cvd install! should take ya 40 minutes to an hour.
Please come back and let up know how these things are holding up!
11-22-2011, 09:35 PM
This seems to be 3rd-party product support and as such is not allowed in the Traxxas forums.
Powered by vBulletin® Version 4.1.5 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.