Velenion not working bearing burned out

[zman4x4]

If i send it to traxxas will they replace it or fix it

[ksb51rl]

Need a bit of a crystal ball here. Is it under initial warranty? Has it been abused? Traxxas motors (IIRC) are not covered by their Lifetime Electronics Warranty. They **may** hook you up anyway, depending on the particulars. Traxxas has excellent customer service.

[Shcuck]

Can you just replace the 2 bearings? That would be cheaper than a full replacement.

[ksb51rl]

Yes, replacing bearings is an option on most motors.

Traxxas rebuild kit (http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXSGY2&P=ML)

[jathomas3]

I had a Velineon motor with bad bearings. I replaced them with Boca Econo Series (black seal) and it is as good as new. I think the metal shielded bearings that come stock in the motor aren't too good as that motor didn't have much use and I maintain my trucks pretty good.

[ksb51rl]

Sealed bearings are not usually recommended for motor internals. Metal shields cause less drag. I'm glad the Bocas are working for you. I like them too, in general.

[jathomas3]

Sealed bearings are not usually recommended for motor internals. Metal shields cause less drag. I'm glad the Bocas are working for you. I like them too, in general.

Yeah, I was kinda wondering if they were a good choice. I had them on hand and I figured I would see how they hold up and replace them with some actual motor bearings if neeed. I've problably run about 5-6 packs through the motor since changing the bearings and they are good so far.

[Gadgeteer]

If i send it to traxxas will they replace it or fix it

If you call traxxas they may send you replacement bearings.

I had issues with the stock motor bearings, i suddenly felt the drivetrain had some binding and traced it down to the motor.

I thought for sure the bearings were done, but i just used some bearing oil and months of use and I still havent used the bearing replacements I have....

Just oil the motor bearings after use and they should last a long time....

[phildogg]

You could try and oil them, contact traxxas and get a rebuild kit on the way.. That way maybe it will run till the kit or bearings from traxxas get there..
phil

[jeff hughes]

Two bearings are six bucks at LHS, it's five minute fix, why bother sending to traxxas?

[mass-tmaxx]

i keep bearings in my tool box for these VXL motors , they go bad all the time from dirt and dusty tracks .... you don't need the $12.00 kit .

[El Sob]

The bearings are fairly easy to replace. I use a socket that fits in the hole and tap on the bearing until it comes out.