View Full Version : Sway Bars
I just bought the sway bars and was wodering if anyone knew wether u had to take the suspension arms off to fit them on. If not does anybody have any tips on getting them on.
02-04-2001, 03:44 PM
You shouldn't have to take the arms off on the back, just use some tiny needle nose to hold the holders, then thread the screw in.
On the front you'll need to remove the tie bar and put the sway bar behind it. To do that you can take off the 4 front suspension screws, remove the foam bumper, manuever the bumper plate out from under the front diff, take off the clips from the front of the front hunge pins, pull off the tie bar, pop in the sway bars...reverse order to put it all back together in. Hope it helps!
Thanks alot Nismo your instructions worked great!!!Does anyone have any suggestions on which holes I should have the sway bars in?
[This message has been edited by Dan (edited 02-05-2001).]
Powered by vBulletin® Version 4.2.2 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.