Making Proline F-650 Body Fit

[Cultivate]

Can you use the front 5335 bumper piece on the back to lose the wing and allow the truck bodies to fit while keep a bumper on? if so, will the wheelie bar still mount? I already broke the rear body mount bashing without a rear bumper/wing :fear: . (luckily I had one from ordering revo mounts so my truck body would fit :D )

[tonkajeep34]

you can use the hoop on the back to mount the bumper... not sure about the wheelie bar as i don't have one.

[scoobydew]

Someone has pics of his 2 f 650's a red and blue one. I would ask him. Look in the gallery section to find the bodies. I just took off my wing and left the front bumper on as i don't use the wheelie bar either.

[mistercrash]

To be able to use the front and rear bumpers with the F650 body, I used a second rear hoop on the front. Both hoops have to be installed up side down so that they slope down instead of up. Since the body is so long, I had to use plastic spacers that come with the Traxxas extended rear arms. They are made to bring the rear bumper further out, I used two spacers thick on front and rear bumpers so I used a total of 8 spacers. Then I had to go to the hardware store and get M4 screws that were 20 mm long. Then it was just a matter of trimming U shaped slots on the body to slip around those spacers.

[Cultivate]

sweet. thanks man!