pro-line 23mm adapters

[fuzztub]

i just bought a set of 40 series mashers, Pro-Line Commando 3.8", and the 23mm adapters for my erbe. i had the 17mm adapter on from the stock set-up and realized i needed to get the traxxas 5mm nut to hold the adapter on as well.

but i'm still having a problem, the axles keep turning and spinning inside the adapters. i noticed on the back of them is a cut out. is there something to put through the hole on the axle that the adapter sits on to keep it from slipping? kind of like the set screw on the 17mm adapter from traxxas?

thanks for any help!

[zrau17]

Yes, its just a drive pin. It's what would come normally with the 14mm hex. This (http://www.buytraxxas.com/product_info.php?cPath=1_2962_2920&products_id=1555) is what you need.

[fuzztub]

thanks! i new there had to be a specific part. would have been nice to have instructions or something included from pro-line.