View Full Version : rear summit locker
04-17-2009, 06:04 PM
instead of having the front locker only option, i was in a thread earlier and now I cant find it, it brifely explained how he switched two wires, and had a rear locker option only instead of a front locker
I want this, i dont see a point in having just front locked..
I guess i need to get out my soldering gun and some flux and wire and heat shrinks, and wait for the response.
04-17-2009, 06:31 PM
It's super easy, just swap the servo leads to the T-lock controller. No soldering required!
04-17-2009, 08:30 PM
be right back *Goes to shop*
04-17-2009, 08:42 PM
Awesome, I just did this, took me less then a minute!!:) :)
04-17-2009, 09:17 PM
ah yes that was easy
04-17-2009, 09:23 PM
took me longer as i had to clean out some mud around the wires,
Its nice to have an air compressor thats for sure...
04-17-2009, 10:48 PM
You had mud in the RX box?!? That can't be good!!
04-18-2009, 12:48 AM
no, I said "around" the wires.. i just cleaned up some mud , no mud in anything importent..... yet. hahha
04-18-2009, 07:14 AM
Oh ok, I thought it sounded odd. I love being able to hose the Summit off after a muddy run. I usually don't let any mud sit on the Summit long enough to dry, unless I am somewhere where a hose isn't available. Then it has to stay on until I get back to my house.
But I know what you mean, I hate finding mud dried up in places I missed with the hose!! Takes forever to chip, and blow it out!!
Powered by vBulletin® Version 4.2.2 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.