Low Speed screw

[Mako-Slayer]

Question for a new TRAXXAS newbie. Had MGT and Ofna engines but this one is kind of bothering me. On other engines, the low speed screw was always kind of tight(snug) but not too tight to set or adjust. Noticed when going over my Slayer before taking her out for breakin that the Low speed screw moves freely and not snug at all. IS THAT OK? If it is, won't it move around when I am on the dirt and change settings? seems that vibrations might move it. Won't put shoo-goo on because I know I will prob adjust settings according to weather temps, etc.

[hoovdog]

It's always hard to judge because what's loose to you might feel normal to me. With that said, the LSN does adjust quite easily on these engines as in it doesn't take much force to make an adjustment. I you feel it's overly loose, remove the needle to inspect for any damage to the threads. Other than that, mark where you adjust it and periodically check while running to see if it is moving.

[Mako-Slayer]

Thanks. Maybe that is what happens when you get to be an oldie like me and lose their touch...LOL