brushless motor mount and other accessories

[HoovHartid]

I have been looking across the pre-order sites and so far have not been able to find the following

1) The "seperate motor plate engineered for clean low-slung single motor installation"

2) The quick-release wheelie bar (could be rumor)

If anyone come across these or other cool accessories for th E-revo please post the site here.

[mbeatle]

Doesn't the new E-Revo use the 3905 single motor plate (http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXTKH7&P=7)? I know they use the same transmission.

Can't help you with the wheelie bar.

[HoovHartid]

I don't know for sure, but looking at the two--they don't seem to look the same.

e-maxx plate seems to put the motor over the gearbox..
http://www.rceasy.com/wp-content/uploads/2007/11/single-motor-plate.jpg

e-revo plate puts the motor towards the back of the trans and lower to the chassis...
http://www.rcuniverse.com/forum/m_7395431/anchors_7395431/mpage_1/key_/anchor/tm.htm#7395431

[Sneaky Pete]

2) The quick-release wheelie bar (could be rumor)

I'm pretty sure the quick-release wheelie bar is not a rumor. It was shown at RCX and demonstrated by the Traxxas rep over and over. Look in the original video by Espressoman (?) and you'll see him popping it off and on. Now, PERHAPS it doesn't make it on the production version, but I seriously doubt that.