question about wheels

[ravenmt]

has anyone ever tried to adapt the wheels form a losi or associated over to traxxas?
i know the will fit my rs4 mt and so will traxxas. I am looking at the aluminum finnish wheels from rpm.

[JonnyBCarNut]

I know that the rears off of those trucks will work if you just use the axel pin and not the hex piece. But remember that the offset is different from front to rear on the stampede and rustler, so you cant exactly use the same wheels for both. I had to experiment with this myself when buying foams. It might take some grinding down on the outside of the center hole to make sure the wheel nut has enough room to lock on. Dont buy the front wheels of an associated (maybe Losi too, but not sure) because they're made to hold the bearings in them instead of the axel carrier, unlike traxxas. Other than that there's not much of a problem. Hope that helps. Later

[JonnyBCarNut]

Oh ya, RPM makes Talon and Claws to fit the Traxxas trucks. Pro-line makes the Agitator wheels in chrome too. Later

[ravenmt]

thanks guys. i just saw the agitators. think i will go with them

[BChase1986]

yes i have made the mistack of geting some of those and had to mack my hex adapters untill thay wher round and then i had to put bushings on the other side

[BChase1986]

so yes u can do it the thing is do u whant to do all the stuf to get to that pont