View Full Version : removal of top plate HELP
03-18-2001, 05:24 PM
if some one can give me step by step directions or a good pic. of how to take it off would be helpful havnt went that far yet on disassembly actually havnt figured it out want to take motor out also to give it a good cleening. if you let of you loose
03-18-2001, 05:33 PM
take out every screw on the top of the plate starting in front of the shock tower, then one right down the middle of the bottom plate, them two at front of gas tank, then four towards middle of tank then the three right at the back of the top plate. if you want to keep the servo mounted to it you have to disconect the steering links.
[This message has been edited by Racer R (edited 03-18-2001).]
03-18-2001, 08:16 PM
i just took off almost everything on my rustler yesterday. little worried but think ill be ok. what i did was to stick the screws on a piece of tape then fold the tape over on the screws to hold them and then wrote on the tape where the screws go, so when i get back to it ill have some idea of what they go. only problem is that now i want to replace parts with hopup stuff.
Powered by vBulletin® Version 4.1.5 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.