View Full Version : ok i had to come to the forum for this one because troubleshooting doesn't help!!!!!
02-01-2004, 09:43 AM
Ok, my steering works and my throttle doesn't BUT if i turn the throttle trim left or right it will go backwards or fowards depending on direction. If i put the throttle trim to the right so it goes foward and then pull back on the throttle it will stop. Then if i let go it will go again. So what is the problem with the throttle, what can i do, i want to know so i can test my plow!
02-01-2004, 09:59 AM
if you touch the throttle trim the settings for the EVX will mess up.. so most likely you should just reset your EVX, which isnt very hard. try it out and tell me if it works man.
02-01-2004, 10:33 AM
I had similar problems and it turned out that the battery pack on the right side was bad. Only puting our 4 volts instead of 7.2. Soon as I installed new batteries everything was ok.
02-01-2004, 10:34 AM
Originally posted by rusty2046
....... i want to know so i can test my plow!
Just a little word of caution. If you are trying to push/tow things with your RC, you can overheat and damage the speed control and/or motors. These things are geared for speed, not pulling. Check your ESC and motor temps frequently!
As far as the throttle problem goes, I agree with maxxman - try initializing the ESC again and let us know what happens!
02-01-2004, 04:10 PM
if the throttle trim makes it move, i bet everything but the radio (tx) is ok.
im guessing some how the tx throttle (trigger) got screwed up... i would try and make sure everythings still conected inside, but its hard to do it without seeing it myself...
Powered by vBulletin® Version 4.2.2 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.