View Full Version : throttle return spring for TRX pro .15
12-30-2003, 02:34 AM
Do they make one for the TRX pro? On towerhobbies I only found one for the 2.5. Do they even make one for rotary carbs?
Thanx in advance for any replies.
01-03-2004, 12:52 PM
There is a trs made for the Pro 15, but it is actually a generic one that fits alot of different R/C's. I had one installed from teh shock tower to the brake side of the steering horn.
01-05-2004, 02:38 AM
I used an Associated kit that worked great.(hope that name is ok to say here)It has the right size spring and a bracket that is held in place by a motor mount screw and other end goes to extra eye on throttle arm of carb.Check it out here (http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXUP98&P=7)
01-05-2004, 12:48 PM
Save a few bucks and go to Ace hardware and buy a #73 spring for less then $1. Hook it up to an extra hole on the throttle arm and the other end to the screw near the front of the gas tank.
01-05-2004, 04:04 PM
Carb flip and throttle return spring installation. (http://www.maxxpitstop.com/tech.php?aid=8)
01-11-2004, 02:16 AM
Wow OvalQueen! U read my mind, I might have posted this before I did the carb flip I can't remember. But it wasn't for a return spring, it was so I could get at the lsn. Now I can't get at the idle screw now though. I can tune it but not easy. I read the article Ovalqueen and it helped me all the way. Thanx everybody!
Powered by vBulletin® Version 4.2.2 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.