help!!!!!

[Racer]

I just got a new starter box for my Rustler and now it won't start at all. The black flywheel thingy doesn't even turn the flywheel and when it does it does very slowly!

[Maximum ST]

Make sure the batteries are fully charged

------------------
Dude lay off the 60 percent!

[Psymbian]

Yeah, even being a little off peak you lose the power to turn over the engine. I have a decent battery and after it was too low to start the engine, I popped it in one of my cheap cars and ran it for like 15 minutes.

You also should check that the brake isn't on!

------------------
-thePsymbian
nitro rustler

[This message has been edited by Psymbian (edited 01-17-2001).]

[Racer]

The batteries are fully charged.

[Maximum ST]

Is it ok now,maybe one of the motors burnt out

------------------
Dude lay off the 60 percent!

[Cosper11]

Try loosening the glow plug a little. The trx pro is a pretty high compression engine. Also make sure it's not hydro locked. If it turns with the plug a little loose you can start it, and then tighten the plug back down. It helps with my recoil starter, maybe it'll help here.

------------------
Nitro Sport
Pro.15 MIP 360 Stinger

[DG]

Did you make the engine a non pull start engine?

[Hrod_504]

i think i know what is wrong your oneway baring is turned the wrong way the round part should be facing the engine

[Racer]

I still have the E-Z start on the engine. What do you mean The one-way bearing is the wrong way? Starter boxes have no one-way bearing...

------------------
Nitro Rustlers and T-Maxxes kick @$$

[TRXnitroPOWER]

IF your EZ starter is still on there then the starter box has to turn over the engine and it has to turn the EZ starter gears over to, Remove the EZ starter or the oneway bearing then try again.

[ratboyracer]

The one way bearing is backwards or it is bad... that is the hex shape bearing on the crank shaft part of the starter...

[Nitro Chicken]

Hi there Racer! It could be a couple of things. First try clearing a flood on your engine. It could also be a slipping one way bearing (needs to be cleaned), a loose motor pinion, a weak battery or a stripped EZ-Start gear. Clickhere (http://www.traxxas.com/support/troubleshooting/nitro/nrustler/trx_trouble_nrustler_e03.htm) for a troubleshooting guide!

------------------
Back up till glass breaks, then gun it!