View Full Version : Size of hex nuts on rims
02-16-2001, 03:11 PM
I know its a dumb question...what are the size of the stock nuts holding the rims on...thanks a bunch!
02-16-2001, 03:55 PM
I don't know what size they are, I got rid of the stock nuts a little while ago for Aluminum Knock off hubs. You can tighten them with your hands. I was using a pair of needle nose pliers before. Traxxas should of put a wrench in the box for this, they did for everything else.
02-16-2001, 04:19 PM
A 5/16 nut driver works well.
02-16-2001, 04:41 PM
I believe there 5mm
EMAXX Type R
02-16-2001, 05:56 PM
I got some of those knock off nuts for my RC10GT and I liked them until I ploped in a mugen engine, they kept vibrating off, I lost one for good. But I'm sure they would be great on any electric car. But on a maxx how often do you really take tires off?
02-16-2001, 07:34 PM
I got mine from rcraven.com (http://www.rcraven.com) . It came with plumbing tape to help secure them. I have not had any problems thus far, and they look cool. Check them out, I have the Gold ones.
02-17-2001, 11:17 PM
They are 8mm.
Powered by vBulletin® Version 4.1.5 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.